Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Background: The valgus cut angle (VCA) of the distal femur in Total Knee Arthroplasty (TKA) is measured preoperatively on three-joint alignment radiographs. The anatomical axis of the femur can be described as the anatomical axis of the full length of the femur or as the anatomical axis of the distal half of the femur, which may result in different angles in some cases. During TKA, the anatomical axis of the femur is determined by intramedullary femoral guides, which may follow the distal half or near full anatomical axis, based on the length of the femoral guide. The aim of this study was to compare using the anatomical axis of the full length of the femur versus the anatomical axis of the distal half of the femur for measuring VCA, in normal and varus aligned femurs. We hypothesized that the VCA would be different based upon these two definitions of the anatomical axis of the femur.

Methods: Full-length weight bearing radiographs were used to determine three-joint alignment in normal aligned (Lateral Distal Femoral Angle; LDFA = 87º ± 2º) and varus aligned (LDFA >89º) femurs. Full-length anatomical axis-mechanical axis angle (angle 1) and distal half anatomical axis-mechanical axis angle (angle 2) were measured in all subjects by two independent orthopedic surgeons using a DICOM viewer software (PACS). Angles 1 and 2 were compared in normal and varus aligned subjects to determine whether there was a significant difference.

Results: Ninety-seven consecutive subjects with normally aligned femurs and 97 consecutive subjects with varus aligned femurs were included in this study. In normally aligned femurs, the mean value of angle 1 was 5.05° ± 0.76° and for angle 2 was 3.62° ± 1.19°, which were statistically different (). In varus aligned femurs, the mean value of angle 1 was 5.42° ± 0.85° and for angle 2 was 4.23° ± 1.27°, which were also statistically different ().

Conclusion: The two different methods of outlining the anatomical axis of the femur lead to different results in both normal and varus-aligned femurs. This should be considered in determination of the valgus cut angle on pre-operative radiographs and be adjusted according to the length of the intramedullary guide.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC6110428PMC

Publication Analysis

Top Keywords

anatomical axis
36
varus aligned
20
aligned femurs
20
distal half
16
valgus cut
12
angle
12
cut angle
12
axis femur
12
anatomical
11
axis
11

Similar Publications

Self-efficacy and anatomical knowledge have been shown to be important in the development of medical students. Validated instruments designed to measure the construct of anatomical self-efficacy during the clinical years of medical school are limited. In this study, the Anatomical Self-Efficacy Instrument for Clinical Clerkships (ASEI-CC) was developed, and evidence for the reliability of the scores and the validity of the interpretations of the scores was gathered.

View Article and Find Full Text PDF

Congenital absence of posterior elements of axis: case series, literature review and classification proposal.

World Neurosurg

September 2025

Department of Orthopedics, Xinqiao Hospital, Army Military Medical University, Chongqing 400037, China. Electronic address:

Objective: The purpose of this study is to present five new cases of congenital absence of posterior elements of the axis (C2), totaling 17 cases report in the literature, and to propose an anatomical classification system for this rare condition for standardizing its management.

Methods: A retrospective review of five patients diagnosed and surgically treated for the absence of C2 posterior elements was conducted from 2017 to 2024. Clinical characteristics were summarized, and imaging studies, including X-rays, CT, and MRI were performed to define abnormalities and cord compression.

View Article and Find Full Text PDF

Glioblastoma (GBM) exhibits remarkable intra-tumoral heterogeneity, which contributes to therapeutic resistance and poor clinical outcomes. In this study, we employed integrative single-cell RNA sequencing analysis across two complementary public datasets encompassing diverse cellular populations from GBM centre and periphery regions to elucidate potential spatial molecular programmes driving tumour progression. Our analyses revealed substantial transcriptomic divergence between anatomically distinct tumour regions, with NUCB2 emerging as significantly upregulated in centre-residing neural progenitor cell-like (NPC-like) tumour cells.

View Article and Find Full Text PDF

The posterior tibial slope, used to define the angulation of the tibial plateau relative to the tibial shaft, is an important radiographic measurement that has gained significant interest recently. Increasing biomechanical and clinical literature has demonstrated the importance of evaluating posterior tibial slope due to its impact on knee kinematics. Although risk of anterior cruciate ligament (ACL) injury and graft rupture is multifactorial, studies have demonstrated that increased posterior tibial slope is likely a contributing factor.

View Article and Find Full Text PDF

[Management of forearm shaft fractures : Challenges and solution approaches].

Unfallchirurgie (Heidelb)

September 2025

Klinik für Orthopädie und Unfallchirurgie, Klinikum Nürnberg, Paracelsus Medizinische Privatuniversität, Breslauer Straße 201, 90471, Nürnberg, Deutschland.

Forearm shaft fractures are the most common fractures of the upper extremity in young adults. By definition, these fractures are diaphyseal fractures; however, due to the complex functional unity formed by the forearm shaft during motion both bone forearm fractures are treated as intra-articular fractures [1, 3]. This is why the gold standard of treatment in adults is osteosynthesis.

View Article and Find Full Text PDF