98%
921
2 minutes
20
Three monomeric polyoxometalates [M(CHN)][α-PMoMoOZn(CHN)]·2HO (M-PMoZn, M = Fe, Co, Ru) with {Zn(bpy)} units capped on reduced α-Keggin polyanions and [M(bpy)] counter-ions were synthesized under hydrothermal conditions. The 1D polymer [N(CH)][Ru(CHN)][α-PMoMoO] (Ru-PMo) was prepared by a similar strategy, in the absence of 2,2'-bpy ligands. In this chain capped reduced Keggin anions are linked via Mo-O-Mo bridges and are surrounded by both tetrabutylammonium cations and [Ru(bpy)] counter-ions. The compounds were characterized in the solid state by single crystal and powder X-ray diffraction and IR spectroscopy and in solution by P NMR spectroscopy. P diffusion ordered NMR spectroscopy (DOSY) indicates that the diffusion coefficient of the dissolved species of Ru-PMo corresponds to a dimeric structure. Magnetic susceptibility measurements performed on Ru-PMo show the existence of antiferromagnetic interactions between the d electrons of the six Mo centers, with a singlet spin ground state. However, attempts to fit the data in the 2-300 K temperature range with Heisenberg Hamiltonians adapted for 0 or 1D systems suggest that these electrons are delocalized. Density Functional Theory (DFT) and Wave Function Theory (WFT) calculations indicate a migration of the electrons of the capping Mo centers into the PMo units at high temperature, allowing the rationalization of the experimental observations.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1039/c8dt01313f | DOI Listing |
Beilstein J Nanotechnol
August 2025
Department of Chemistry, McGill University, 801 Sherbrooke Street West, Montreal, QC H3A 0B8, Canada.
The preparation of multimodal nanoparticles by capping magnetic iron oxide nanoparticles (IONPs) with functional organic molecules is a major area of research for biomedical applications. Conjugation reactions, such as carbodiimide coupling and the highly selective class of reactions known as "click chemistry", have been instrumental in tailoring the ligand layers of IONPs to produce functional biomedical nanomaterials. However, few studies report the controls performed to determine if the loading of molecules onto IONPs is due to the proposed coupling reaction(s) employed, or some other unknown interaction with the IONP surface.
View Article and Find Full Text PDFPhys Chem Chem Phys
September 2025
Masaryk University, Faculty of Science, Department of Chemistry, Kotlářská 2, Brno, 611 37, Czech Republic.
Structural and magnetic properties of ultra-small tetrahedron-shaped iron oxide nanoparticles were investigated using density functional theory. Tetrahedral and truncated tetrahedral models were considered in both non-functionalized form and with surfaces passivated by pseudo-hydrogen atoms. The focus on these two morphologies reflects their experimental relevance at this size scale and the feasibility of performing fully relaxed, atomistically resolved first-principles simulations.
View Article and Find Full Text PDFACS Omega
September 2025
Materials and Manufacturing Directorate, AFRL/RXEE, Air Force Research Laboratory, Wright-Patterson AFB, Ohio 45433, United States.
This study addresses a critical limitation in direct bonded copper (DBC) materials used in power electronics by introducing a copper-zirconium (Cu/Zr) alloy interposing layer at the copper-ceramic interface. This novel design aims to mitigate mechanical stress induced by mismatched material properties, such as the coefficient of thermal expansion (CTE) and elastic modulus, during thermal cycling. The key findings of this study are (1) thermal fatigue improvement: Test samples with the Cu/Zr interface layer (Cu-Cu/Zr-AlN) three times enhanced thermal fatigue resistance, surviving 30 thermal cycles from -55 to 300 °C before delamination, while standard DBC substrates without the Cu/Zr layer failed after just 10 cycles, indicating a performance improvement with the Cu/Zr alloy, (2) durability projections: Based on the Coffin-Manson model, if the upper temperature is capped at 150 °C, the Cu-Cu/Zr-AlN substrates are projected to survive approximately 1372 cycles, underscoring their potential for long-term reliability, and (3) stress mitigation: The Cu/Zr alloy layer bridges the CTE disparity between copper and ceramic, reducing mechanical stress and improving structural integrity across a broad temperature range (-55 to 300 °C).
View Article and Find Full Text PDFACS Omega
September 2025
School of Chemistry, University of St Andrews, St Andrews, Fife KY16 9ST, United Kingdom.
The present research reports the synthesis of poly-[ethylene oxide]-based composite films (500 μm) containing metal nanoparticles (NPs) [Ag ( ∼ 6 nm), Cu ( ∼ 25 nm), and Fe ( ∼ 35 nm)] as the mobile phase. The novelty of the study is in the corroboration of a plausible mechanism for the generation of metal NPs through green synthesis using herbal extracts of (Tea) and (Neem). Density functional theory (DFT) is used to optimize the phytoreductants present in both biosources, wherein the reducing and/or stabilizing functional entities are primarily hydroxyl groups (-OH).
View Article and Find Full Text PDFMar Pollut Bull
September 2025
Department of Ocean Engineering, Pukyong National University, 45 Yongso-ro, Nam-Gu, Busan 48513, Republic of Korea. Electronic address:
Coastal sediments in semi-enclosed bays are particularly susceptible to contamination due to limited water circulation and ongoing contaminant input. In Masan Bay, a heavily impacted coastal area in Korea, sediment remediation is essential to alleviate the effects of organic enrichment and hypoxia. This study investigated the effectiveness of oyster shell capping as an in-situ remediation technique by assessing its impact on sediment environment, microbial communities, and macrobenthic fauna.
View Article and Find Full Text PDF