98%
921
2 minutes
20
We report a simple, robust fluorescence biosensor for the ultra-sensitive detection of Clostridium botulinum Neurotoxin Type A (BoNT/A) in complex, real-world media. High intrinsic signal amplification was achieved through the combined use of ultra-bright, photostable dye-doped nanoparticle (DOSNP) tags and high surface area nanoporous organosilicate (NPO) thin films. DOSNP with 22 nm diameter were synthesized with more than 200 times equivalent free dye fluorescence and conjugated to antibodies with average degree of substitution of 90 dyes per antibody, representing an order of magnitude increase compared with conventional dye-labeled antibodies. The NPO films were engineered to form constructive interference at the surface where fluorophores were located. In addition, DOSNP-labeled antibodies with NPO films increased surface roughness causing diffuse scattering resulting in 24% more scattering intensity than dye-labeled antibody with NPO films. These substrates were used for immobilization of capture antibodies against BoNT/A, which was further quantified by DOSNP-labeled signal antibodies. The combination of optical effects enhanced the fluorescence and, therefore, the signal-to-noise ratio significantly. BoNT/A was detected in PBS buffer down to 21.3 fg mL(-1) in 4 h. The assay was then extended to several complex media and the four-hour detection limit was found to be 145.8 fg mL(-1) in orange juice and 164.2 fg mL(-1) in tap water, respectively, demonstrating at least two orders of magnitude improvement comparing to the reported detection limit of other enzyme-linked immunosorbent assays (ELISA). This assay, therefore, demonstrates a novel method for rapid, ultra-low level detection of not only BoNT/A, but other analytes as well.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.bios.2012.08.063 | DOI Listing |
Biosensors (Basel)
June 2024
Columbia Environmental Research Center, U.S. Geological Survey, 4200 New Haven Road, Columbia, MO 65201, USA.
The scope of this study was to apply advances in materials science, specifically the use of organosilicate nanoparticles as a high surface area platform for passive sampling of chemicals or pre-concentration for active sensing in multiple-phase complex environmental media. We have developed a novel nanoporous organosilicate (NPO) film as an extraction phase and proof of concept for application in adsorbing hydrophobic compounds in water and sediment. We characterized the NPO film properties and provided optimization for synthesis and coatings in order to apply the technology in environmental media.
View Article and Find Full Text PDFInorg Chem
September 2023
Institute of Inorganic Chemistry, Graz University of Technology; Stremayrgasse 9/V, 8010 Graz, Austria.
The aim of this study was the preparation of different amorphous silicon-carbon hybrid thin-layer materials according to the liquid phase deposition (LPD) process using single-source precursors. In our study, 2-methyl-2-silyltrisilane (methylisotetrasilane; ), 1,1,1-trimethyl-2,2-disilyltrisilane (trimethylsilylisotetrasilane; ), 2-phenyl-2-silyltrisilane (phenylisotetrasilane; ), and 1,1,2,2,4,4,5,5-octamethyl-3,3,6,6-tetrasilylcyclohexasilane (cyclohexasilane; ) were utilized as precursor materials and compared with the parent compound 2,2-disilyltrisilane (neopentasilane; ). Compounds - were successfully oligomerized at λ = 365 nm with catalytic amounts of the neopentasilane oligomer ().
View Article and Find Full Text PDFJ Cosmet Dermatol
December 2023
NPO Health Institute Research of Skin, Tokyo, Japan.
Objectives: The aim of this study was to examine the potential for S-LEC™ Solar Control Film L, a heat insulating interlayer film for laminated glass developed by Sekisui Chemical Co., Ltd., to reduce the burning sensation caused by near infrared (NIR) radiation.
View Article and Find Full Text PDFMaterials (Basel)
February 2022
Department of Materials Chemistry and Bioengineering, National Institute of Technology, Oyama College, 771 Nakakuki, Oyama 323-0806, Japan.
We report the morphology control of a nano-phase-separated structure in the photoactive layer (power generation layer) of organic-inorganic hybrid thin-film solar cells to develop highly functional electronic devices for societal applications. Organic and inorganic-organic hybrid bulk heterojunction solar cells offer several advantages, including low manufacturing costs, light weight, mechanical flexibility, and a potential to be recycled because they can be fabricated by coating them on substrates, such as films. In this study, by incorporating the carrier manager ladder polymer BBL as the third component in a conventional two-component power generation layer consisting of P3HT-the conventional polythiophene derivative and titanium alkoxide-we demonstrate that the phase-separated structure of bulk heterojunction solar cells can be controlled.
View Article and Find Full Text PDFAm J Otolaryngol
August 2013
Department of Otolaryngology-Head and Neck Surgery Boston University Medical Center, Boston, MA 02118, USA.
This is a 58 year old male who presented to our institution with foreign body sensation after eating fish the night before. Although lateral soft tissue films of the neck demonstrated a linear foreign body, this was missed and the patient was discharged home. One week later, he re-presented with persistent throat pain.
View Article and Find Full Text PDF