The influences of ambient particle composition and size on particle infiltration in Los Angeles, CA, residences.

J Air Waste Manag Assoc

Department of Environmental and Occupational Health, Rollins School of Public Health, Emory University, Atlanta GA 30322, USA.

Published: February 2006


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Particle infiltration is a key determinant of the indoor concentrations of ambient particles. Few studies have examined the influence of particle composition on infiltration, particularly in areas with high concentrations of volatile particles, such as ammonium nitrate (NH4NO3). A comprehensive indoor monitoring study was conducted in 17 Los Angeles-area homes. As part of this study, indoor/outdoor concentration ratios during overnight (nonindoor source) periods were used to estimate the fraction of ambient particles remaining airborne indoors, or the particle infiltration factor (FINF), for fine particles (PM2.5), its nonvolatile (i.e., black carbon [BC]) and volatile (i.e., nitrate [NO3-]) components, and particle sizes ranging between 0.02 and 10 microm. FINF was highest for BC (median = 0.84) and lowest for NO3- (median = 0.18). The low FINF for NO3- was likely because of volatilization of NO3- particles once indoors, in addition to depositional losses upon building entry. The FINF for PM2.5 (median = 0.48) fell between those for BC and NO3-, reflecting the contributions of both particle components to PM25. FINF varied with particle size, air-exchange rate, and outdoor NO3- concentrations. The FINF for particles between 0.7 and 2 microm in size was considerably lower during periods of high as compared with low outdoor NO3- concentrations, suggesting that outdoor NO3- particles were of this size. This study demonstrates that infiltration of PM2.5 varies by particle component and is lowest for volatile species, such as NH4NO3. Our results suggest that volatile particle components may influence the ability for outdoor PM concentrations to represent indoor and, thus, personal exposures to particles of ambient origin, because volatilization of these particles causes the composition of PM2.5 to differ indoors and outdoors. Consequently, particle composition likely influences observed epidemiologic relationships based on outdoor PM concentrations, especially in areas with high concentrations of NH4NO3 and other volatile particles.

Download full-text PDF

Source
http://dx.doi.org/10.1080/10473289.2006.10464449DOI Listing

Publication Analysis

Top Keywords

particle composition
12
particle infiltration
12
outdoor no3-
12
particle
11
particles
10
ambient particles
8
areas high
8
high concentrations
8
volatile particles
8
no3- particles
8

Similar Publications

Microgravity experiments on board the International Space Station, combined with particle-resolved direct numerical simulations, were conducted to investigate the long-term flocculation behavior of clay suspensions in saline water in the absence of gravity. After an initial homogenization of the suspensions, different clay compositions were continuously monitored for 99 days, allowing a detailed analysis of aggregate growth through image processing. The results indicate that the onboard oscillations (g-jitter) may have accelerated the aggregation process.

View Article and Find Full Text PDF

Investigating microbial and metabolic dynamics in bovine and goat milk during refrigerated storage for 5 days.

Int J Food Microbiol

September 2025

College of Food Science and Engineering, Qingdao Agricultural University, Qingdao, 266109, Shandong, China. Electronic address:

Raw milk is commonly stored at 4 °C prior to processing, a practice that can facilitate psychrotrophic proliferation, and milk physicochemical alterations and quality deterioration. This study aimed to elucidate the dynamic changes and interrelationships among microbiota, physicochemical parameters, and metabolite profiles in raw bovine and goat milk during refrigerated storage at 4 °C over a 5-day period. The results showed that both bovine and goat milk exhibited significant increases in bacterial counts, titratable acidity, zeta potential, and protein particle size, alongside decreases in pH and lipid particle size, as well as changes in color during refrigerated storage at 4 °C.

View Article and Find Full Text PDF

The supported catalytically active liquid metal solution (SCALMS) concept is based on catalytically active metals dissolved in a low-melting-point liquid metal matrix. These solid alloy particles, deposited over a high area support, transform into a liquid alloy under reaction conditions. In this work, GaPt SCALMS materials of varying composition are investigated and focus on the change in the alloy composition during preheating, the actual high temperature propane dehydrogenation at 823 K, and after cool-down.

View Article and Find Full Text PDF

Sodium-ion batteries are promising candidates for large-scale energy storage due to their low cost and resource abundance. However, their cathode materials suffer from poor conductivity and limited cycling stability. Here, we report a Prussian blue (PB)-based cathode hybridized with carboxyl-functionalized carbon nanotubes (CNTs) via a glutamic acid-assisted in situ coordination route.

View Article and Find Full Text PDF

The iron nickel magnesium tetra-oxide (FeNiMgO) nanocomposites (NCs) first reported in this article were synthesized using the sol-gel method. For investigation using powder X-ray diffraction (PXRD), the presence of a cubic structure is confirmed. In Raman spectroscopy, the vibrational modes are investigated.

View Article and Find Full Text PDF