Role of probe design and bioassay configuration in surface enhanced Raman scattering based biosensors for miRNA detection.

The accurate design of labelled oligo probes for the detection of miRNA biomarkers by Surface Enhanced Raman Scattering (SERS) may improve the exploitation of the plasmonic enhancement. This work, thus, critically investigates the role of probe labelling configuration on the performance of SERS-based bioassays for miRNA quantitation. To this aim, highly efficient SERS substrates based on Ag-decorated porous silicon/PDMS membranes are functionalized according to bioassays relying on a one-step or two-step hybridization of the target miRNA with DNA probes.

Real-Time Monitoring of the In Situ Microfluidic Synthesis of Ag Nanoparticles on Solid Substrate for Reliable SERS Detection.

A sharpened control over the parameters affecting the synthesis of plasmonic nanostructures is often crucial for their application in biosensing, which, if based on surface-enhanced Raman spectroscopy (SERS), requires well-defined optical properties of the substrate. In this work, a method for the microfluidic synthesis of Ag nanoparticles (NPs) on porous silicon (pSi) was developed, focusing on achieving a fine control over the morphological characteristics and spatial distribution of the produced nanostructures to be used as SERS substrates. To this end, a pSi membrane was integrated in a microfluidic chamber in which the silver precursor solution was injected, allowing for the real-time monitoring of the reaction by UV-Vis spectroscopy.

Reverse Micelle Strategy for the Synthesis of MnO -TiO Active Catalysts for NH-Selective Catalytic Reduction of NO at Both Low Temperature and Low Mn Content.

MnO -TiO catalysts (0, 1, 5, and 10 wt % Mn nominal content) for NH-SCR (selective catalytic reduction) of NO have been synthesized by the reverse micelle-assisted sol-gel procedure, with the aim of improving the dispersion of the active phase, usually poor when obtained by other synthesis methods (e.g., impregnation) and thereby lowering its amount.

Bispyrene Functionalization Drives Self-Assembly of Graphite Nanoplates into Highly Efficient Heat Spreader Foils.

Thermally conductive nanopapers fabricated from graphene and related materials are currently showing great potential in thermal management applications. However, thermal contacts between conductive plates represent the bottleneck for thermal conductivity of nanopapers prepared in the absence of a high temperature step for graphitization. In this work, the problem of ineffective thermal contacts is addressed by the use of bifunctional polyaromatic molecules designed to drive self-assembly of graphite nanoplates (GnP) and establish thermal bridges between them.

Surface Enhanced Raman Spectroscopy for Quantitative Analysis: Results of a Large-Scale European Multi-Instrument Interlaboratory Study.

Surface-enhanced Raman scattering (SERS) is a powerful and sensitive technique for the detection of fingerprint signals of molecules and for the investigation of a series of surface chemical reactions. Many studies introduced quantitative applications of SERS in various fields, and several SERS methods have been implemented for each specific application, ranging in performance characteristics, analytes used, instruments, and analytical matrices. In general, very few methods have been validated according to international guidelines.

Synthesis of thermoelectric magnesium-silicide pastes for 3D printing, electrospinning and low-pressure spray.

In this work, eco-friendly magnesium-silicide (MgSi) semiconducting (-type) thermoelectric pastes for building components concerning energy-harvesting devices through 3D printing, spray and electrospinning were synthetized and tested for the first time. The MgSi fine powders were obtained through the combination of ball milling and thermal annealing under Ar atmosphere. While the latter process was crucial for obtaining the desired MgSi phase, the ball milling was indispensable for homogenizing and reducing the grain size of the powders.

Osteoporosis-related variations of trabecular bone properties of proximal human humeral heads at different scale lengths.

Osteoporosis (OP) is a skeletal disorder responsible for the weakening of the bone structure and, consequently, for an increased fracture risk in the elderly population. In the past, bone mineral density (BMD) variation was considered the best OP indicator, but recently the focus has shifted toward the variation of microstructural bone parameters. This work is based on the characterisation of 8-mm cylindrical biopsies harvested from proximal humeral heads belonging to healthy and osteoporotic patients, in order to assess the OP-related variations of bone properties at different scale lengths.

Tips and Tricks for the Surface Engineering of Well-Ordered Morphologically Driven Silver-Based Nanomaterials.

Particularly-shaped silver nanostructures are successfully applied in many scientific fields, such as nanotechnology, catalysis, (nano)engineering, optoelectronics, and sensing. In recent years, the production of shape-controlled silver-based nanostructures and the knowledge around this topic has grown significantly. Hence, on the basis of the most recent results reported in the literature, a critical analysis around the driving forces behind the synthesis of such nanostructures are proposed herein, pointing out the important role of surface-regulating agents in driving crystalline growth by favoring (or opposing) development along specific directions.

In situ Raman analyses of the soot oxidation reaction over nanostructured ceria-based catalysts.

To reduce the emissions of internal combustion engines, ceria-based catalysts have been widely investigated as possible alternatives to the more expensive noble metals. In the present work, a set of four different ceria-based materials was prepared via hydrothermal synthesis, studying the effect of Cu and Mn as dopants both in binary and ternary oxides. In situ Raman analyses were carried out to monitor the behaviour of defect sites throughout thermal cycles and during the soot oxidation reaction.

Label-Free SERS Discrimination and In Situ Analysis of Life Cycle in and .

Surface enhanced Raman spectroscopy (SERS) has been proven suitable for identifying and characterizing different bacterial species, and to fully understand the chemically driven metabolic variations that occur during their evolution. In this study, SERS was exploited to identify the cellular composition of Gram-positive and Gram-negative bacteria by using mesoporous silicon-based substrates decorated with silver nanoparticles. The main differences between the investigated bacterial strains reside in the structure of the cell walls and plasmatic membranes, as well as their biofilm matrix, as clearly noticed in the corresponding SERS spectrum.

Optimization and Characterization of Paper-Made Surface Enhanced Raman Scattering (SERS) Substrates with Au and Ag NPs for Quantitative Analysis.

In this work, we present a systematic study on solid Surface Enhanced Raman Scattering (SERS) substrates consisting of Au and Ag nanoparticles (NPs) loaded on filter paper with the dip-coating method. The aim of this work is to explore how a series of parameters (e.g.

SERS-active metal-dielectric nanostructures integrated in microfluidic devices for label-free quantitative detection of miRNA.

In this work, SERS-based microfluidic PDMS chips integrating silver-coated porous silicon membranes were used for the detection and quantitation of microRNAs (miRNAs), which consist of short regulatory non-coding RNA sequences typically over- or under-expressed in connection with several diseases such as oncogenesis. In detail, metal-dielectric nanostructures which provide noticeable Raman enhancements were functionalized according to a biological protocol, adapted and optimized from an enzyme-linked immunosorbent assay (ELISA), for the detection of miR-222. Two sets of experiments based on different approaches were designed and performed, yielding a critical comparison.

Catalytic Oxidation of CO and Soot over Ce-Zr-Pr Mixed Oxides Synthesized in a Multi-Inlet Vortex Reactor: Effect of Structural Defects on the Catalytic Activity.

In the present work, ceria, ceria-zirconia (Ce = 80 at.%, Zr = 20 at.%), ceria praseodymia (Ce = 80 at.

Immobilization of Oligonucleotides on Metal-Dielectric Nanostructures for miRNA Detection.

The development of nanostructured metal-dielectric materials, suitable for biodetection based on surface plasmon resonance and surface enhanced Raman scattering (SERS), requires the refinement of proper biological protocols for their effective exploitation. In this work, the immobilization of DNA probes on nanostructured metal-dielectric/semiconductor substrates has been optimized, to develop a bioassay for the detection of miRNA. To ensure a broad relevance, the proposed biological protocol was applied to different silver-decorated functional supports: porous silicon (pSi), TiO nanotube arrays, and polydimethylsiloxane (PDMS).

Easy Tuning of Surface and Optical Properties of PDMS Decorated by Ag Nanoparticles.

Herein, we report a systematic study on the wetting and optical properties of a PDMS surface coated by silver nanoparticles. A uniform Ag nanoparticles distribution onto PDMS membrane was obtained through dc room-temperature sputtering. The effect of sputtering current and PDMS mixing ratio between oligomer and curing agent was investigated by means of UV-vis spectroscopy and contact angle measurements.

SERS active silver nanoparticles synthesized by inkjet printing on mesoporous silicon.

Unlabelled: Inkjet printing technique is exploited for the synthesis of Ag nanoparticles (NPs) patterned on electrochemically etched silicon-based substrates. The nanostructure morphology, here analyzed by scanning electron microscopy, is dictated by the ink composition and the printing parameters. Under suitable excitation conditions, resonant surface-enhanced Raman scattering (SERS) performed on such metal-dielectric nanostructures can approach single-molecule detection as recently demonstrated on silvered porous silicon synthesized by immersion plating.

Focusing and extraction of light mediated by Bloch surface waves.

The control of emission from localized light sources is an objective of outstanding relevance in nanophotonics. In a recent past, a large number of metallic nanostructures has been proposed to this end, wherein plasmonic modes are exploited as energy carriers on a subwavelength scale. As an interesting alternative, we present here the use of surface modes on patterned dielectric multilayers to deliver electromagnetic power from free-space to localized volumes and vice versa.

Leakage radiation interference microscopy.

We present a proof of principle for a new imaging technique combining leakage radiation microscopy with high-resolution interference microscopy. By using oil immersion optics it is demonstrated that amplitude and phase can be retrieved from optical fields, which are evanescent in air. This technique is illustratively applied for mapping a surface mode propagating onto a planar dielectric multilayer on a thin glass substrate.

A fluorescent one-dimensional photonic crystal for label-free biosensing based on BLOCH surface waves.

A one-dimensional photonic crystal (1DPC) based on a planar stack of dielectric layers is used as an optical transducer for biosensing, upon the coupling of TE-polarized Bloch Surface Waves (BSW). The structure is tailored with a polymeric layer providing a chemical functionality facilitating the covalent binding of orienting proteins needed for a subsequent grafting of antibodies in an immunoassay detection scheme. The polymeric layer is impregnated with Cy3 dye, in such a way that the photonic structure can exhibit an emissive behavior.

Bloch surface wave-enhanced fluorescence biosensor.

A new approach to signal amplification in fluorescence-based assays for sensitive detection of molecular analytes is reported. It relies on a sensor chip carrying a one-dimensional photonic crystal (1DPC) composed of two piled up segments which are designed to increase simultaneously the excitation rate and the collection efficiency of fluorescence light. The top segment supports Bloch surface waves (BSWs) at the excitation wavelength and the bottom segment serves as a Bragg mirror for the emission wavelength of used fluorophore labels.

Hydrogenated amorphous silicon nitride photonic crystals for improved-performance surface electromagnetic wave biosensors.

We exploit the properties of surface electromagnetic waves propagating at the surface of finite one dimensional photonic crystals to improve the performance of optical biosensors with respect to the standard surface plasmon resonance approach. We demonstrate that the hydrogenated amorphous silicon nitride technology is a versatile platform for fabricating one dimensional photonic crystals with any desirable design and operating in a wide wavelength range, from the visible to the near infrared. We prepared sensors based on photonic crystals sustaining either guided modes or surface electromagnetic waves, also known as Bloch surface waves.

Direct patterning of silver particles on porous silicon by inkjet printing of a silver salt via in-situ reduction.

We have developed a method for obtaining a direct pattern of silver nanoparticles (NPs) on porous silicon (p-Si) by means of inkjet printing (IjP) of a silver salt. Silver NPs were obtained by p-Si mediated in-situ reduction of Ag+ cations using solutions based on AgNO3 which were directly printed on p-Si according to specific geometries and process parameters. The main difference with respect to existing literature is that normally, inkjet printing is applied to silver (metal) NP suspensions, while in our experiment the NPs are formed after jetting the solution on the reactive substrate.

A polymer-based functional pattern on one-dimensional photonic crystals for photon sorting of fluorescence radiation.

In this work we introduce the use of a patterned polymer-based surface functionalization of a one-dimensional photonic crystal (1DPC) for controlling the emission direction of fluorescent proteins (ptA) via coupling to a set of two Bloch Surface Waves (BSW). Each BSW dispersion branch relates to a micrometric region on the patterned 1DPC, characterized by a well defined chemical characteristic. We report on the enhanced and spatially selective excitation of fluorescent ptA, and on the spatially-resolved detection of polarized emitted radiation coupled to specific BSW modes.