A development study for liquid- and vapor-fed anode zero-gap bioelectrolysis cells.

iScience

Environmental Biotechnology Group, Department of Geosciences, University of Tübingen, Schnarrenbergstraße 94-96, 72076 Tübingen, Germany.

Published: July 2025


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Improving microbial electrosynthesis could be one solution for transitioning toward sustainable chemical production, offering a pathway to convert CO into valuable commodities from renewable energy sources. Therefore, we further developed liquid- and vapor-fed anode zero-gap bioelectrochemical cells for electromethanogenesis, utilizing a membrane electrode assembly to enhance mass and ohmic transport. Focusing on CH and H production, we tested two ion-exchange membranes with the liquid-fed anode system and selected the best-performing ion-exchange membrane for the vapor-fed anode system. The liquid-fed anode system did not show considerable differences in volumetric CH production rates compared to vapor-fed anode systems. However, the latter demonstrated advantages in reducing electrocatalyst degradation and maintaining stable cell voltages, resulting in the highest reported maximum CH production efficiency of 48.7 L kWh, thus far. The research underscores the need for further optimization to address performance losses and suggests potential for industrial applications of microbial electrosynthesis, highlighting the importance of catalyst protection.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC12272894PMC
http://dx.doi.org/10.1016/j.isci.2025.112959DOI Listing

Publication Analysis

Top Keywords

vapor-fed anode
16
anode system
12
liquid- vapor-fed
8
anode zero-gap
8
microbial electrosynthesis
8
liquid-fed anode
8
anode
6
development study
4
study liquid-
4
vapor-fed
4

Similar Publications

A development study for liquid- and vapor-fed anode zero-gap bioelectrolysis cells.

iScience

July 2025

Environmental Biotechnology Group, Department of Geosciences, University of Tübingen, Schnarrenbergstraße 94-96, 72076 Tübingen, Germany.

Improving microbial electrosynthesis could be one solution for transitioning toward sustainable chemical production, offering a pathway to convert CO into valuable commodities from renewable energy sources. Therefore, we further developed liquid- and vapor-fed anode zero-gap bioelectrochemical cells for electromethanogenesis, utilizing a membrane electrode assembly to enhance mass and ohmic transport. Focusing on CH and H production, we tested two ion-exchange membranes with the liquid-fed anode system and selected the best-performing ion-exchange membrane for the vapor-fed anode system.

View Article and Find Full Text PDF

Polymer electrolyte membrane water electrolyzers (PEMWEs) are a critical technology for efficient hydrogen production to decarbonize fuels and industrial feedstocks. To make hydrogen cost-effective, the overpotentials across the cell need to be decreased and platinum-group metal loading reduced. One overpotential that needs to be better understood is due to mass transport limitations from bubble formation within the porous transport layer (PTL) and anode catalyst layer (ACL), which can lead to a reduction in performance at typical operating current densities.

View Article and Find Full Text PDF

High-rate microbial electrosynthesis using a zero-gap flow cell and vapor-fed anode design.

Water Res

July 2022

Department of Civil and Environmental Engineering, Penn State University, 231Q Sackett Building, University Park, PA 16802, United States. Electronic address:

Microbial electrosynthesis (MES) cells use renewable energy to convert carbon dioxide into valuable chemical products such as methane and acetate, but chemical production rates are low and pH changes can adversely impact biocathodes. To overcome these limitations, an MES reactor was designed with a zero-gap electrode configuration with a cation exchange membrane (CEM) to achieve a low internal resistance, and a vapor-fed electrode to minimize pH changes. Liquid catholyte was pumped through a carbon felt cathode inoculated with anaerobic digester sludge, with humidified N gas flowing over the abiotic anode (Ti or C with a Pt catalyst) to drive water splitting.

View Article and Find Full Text PDF

Electrochemical Approaches for CO Conversion to Chemicals: A Journey toward Practical Applications.

Acc Chem Res

March 2022

Center for Catalytic Science and Technology, Department of Chemical and Biomolecular Engineering, University of Delaware, Newark, Delaware 19716, United States.

Carbon capture, utilization, and sequestration play an essential role to address CO emissions. Among all carbon utilization technologies, CO electroreduction has gained immense interest due to its potential for directly converting CO to a variety of valuable commodity chemicals using clean, renewable electricity as the sole energy source. The research community has witnessed rapid advances in CO electrolysis technology in recent years, including highly selective catalysts, larger-scale reactors, specific process modeling, as well as a mechanistic understanding of the CO reduction reaction.

View Article and Find Full Text PDF

Vapor-Fed Cathode Microbial Electrolysis Cells with Closely Spaced Electrodes Enables Greatly Improved Performance.

Environ Sci Technol

January 2022

Department of Civil and Environmental Engineering, The Pennsylvania State University, University Park, Pennsylvania 16802, United States.

Hydrogen can be electrochemically produced in microbial electrolysis cells (MECs) by current generated from bacterial anodes with a small added voltage. MECs typically use a liquid catholyte containing a buffer or salts. However, anions in these catholytes result in charge being balanced predominantly by ions other than hydroxide or protons, leading to anode acidification.

View Article and Find Full Text PDF