Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Soft soil poses significant challenges in highway engineering due to its low strength and high compressibility. This study proposes using xanthan gum biopolymer as an environmentally friendly agent to improve the mechanical behavior of soft soil. Laboratory tests were conducted to analyze the unconfined compressive strength (UCS) and compressibility of xanthan-gum-stabilized soft soil under dry-wet cycles. Physicochemical analysis was performed to examine the pH value, electrical conductivity, and total dissolved solids (TDS) of the stabilized soil. Additionally, microscopic tests were performed to investigate the stabilization mechanism. The results demonstrate that the UCS of the stabilized soil consistently increases with curing age while it decreases under dry-wet cycles. Moreover, the UCS, durability, and modulus of compressibility of the stabilized soil initially increase significantly and then slightly decrease with increasing xanthan gum dosage. At the optimal xanthan gum dosage (1.5%), the UCS reaches 376.3 kPa at 28 d of curing and drops by only 24.1% even after ten dry-wet cycles, and the modulus of compressibility is enhanced to 37.13 MPa; meanwhile, the corresponding compression index and coefficient of compressibility are reduced to 0.082 and 0.061 MPa, respectively, indicating satisfactory performance of the stabilized soil as highway foundation material. The stabilization mechanism of xanthan-gum-treated soft soil primarily involves the bonding and filling effects of the hydrogel resulting from the hydration of xanthan gum. These findings suggest that xanthan gum is a promising and effective stabilizing agent for soft soil as it can significantly reduce soil water content and void ratio.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC12157328PMC
http://dx.doi.org/10.3390/polym17111532DOI Listing

Publication Analysis

Top Keywords

soft soil
24
xanthan gum
24
stabilized soil
16
stabilization mechanism
12
dry-wet cycles
12
soil
11
mechanical behavior
8
gum biopolymer
8
modulus compressibility
8
gum dosage
8

Similar Publications

Transient electronics for sustainability: Emerging technologies and future directions.

Beilstein J Nanotechnol

September 2025

Department of Materials Science and Engineering, Seoul National University, Seoul, 08826 Republic of Korea.

Transient electronics are emerging as a promising class of devices designed to disappear after a defined operational period, addressing growing concerns over sustainability and long-term biocompatibility. Built from biodegradable materials that undergo hydrolysis or enzymatic degradation, these systems are particularly well suited for temporary implantable applications, such as neural monitors, wireless stimulators, and drug delivery vehicles, as well as environmentally benign electronics for soil or aquatic disposal. Despite their potential, key challenges remain in expanding the material set for diverse functionalities, achieving high-density integration for advanced operations, and enabling precise lifetime control through strategies such as protective encapsulation.

View Article and Find Full Text PDF

Removal and inactivation of human coronavirus surrogates from hard and soft surfaces using disinfectant wipes.

Appl Environ Microbiol

September 2025

Department of Food, Nutrition, and Packaging Sciences, Clemson University, Clemson, South Carolina, USA.

Disinfectant wipes are widely used to reduce microbial contamination on surfaces, yet there is limited information on how viruses are physically removed or chemically inactivated during wiping. This study aimed to address this gap by comparing the contributions of physical removal and chemical inactivation to overall disinfection efficacy. Glass and vinyl coupons were contaminated with SARS-CoV-2 surrogates, bovine coronavirus (BCoV), or human coronavirus OC43, at an initial titer of 5-6 log TCID/surface with 5% soil load.

View Article and Find Full Text PDF

The increasing global demand for food and the adverse environmental impacts of excessive agrochemical use highlights the urgent need for sustainable and scalable seed treatment technologies. This paper reports a novel photothermal seed coating (QC@SCCNTs) with high biocompatibility, exceptional photothermal efficiency, and notable reusability, serving as an effective alternative to conventional chemical treatments. The coating consists of sericin-functionalized carboxylated carbon nanotubes (SCCNTs) electrostatically complexed with quaternary ammonium chitosan (QC), forming a composite film (QS film).

View Article and Find Full Text PDF

First Report of Root-Knot Nematode, , on Tree Houseleek () in the United States.

J Nematol

February 2025

Department of Nematology, University of California, Riverside, 900 University Ave., Riverside, CA 92521.

, or tree houseleek (), is a bushy, perennial succulent and a popular ornamental plant in regions such as California, New Zealand, Australia, Sicily, Gibraltar, and Chile. It features rosettes of soft, waxy leaves at the tips of sparsely branched or occasionally single, bare stems. It is drought-tolerant and has a variety of colors and forms, making it a popular ornamental plant.

View Article and Find Full Text PDF

A comprehensive study on damage prediction of pile foundations of inclined high rise buildings and the effect of compaction grouting.

Sci Rep

August 2025

Beijing Hengxiang Hongye Foundation Reinforcement Technology Co. Ltd, Beijing, 100097, China.

The construction of high-rise buildings in complex soft soil layers is highly prone to uneven settlement of the foundation, which in turn induces building tilting. In severe cases, it can lead to overall collapse accidents. Due to its advantages of causing less damage to the main structure and having a smaller impact on the surrounding environment, compaction grouting is widely used in the inclined high-rise buildings' deviation correction projects.

View Article and Find Full Text PDF