Study on the preparation mechanism and dephosphorization effect of SW-ceramsite.

Sci Rep

Dongying Shengfeng Environmental Protection Technology Co., Ltd, Dongying, 257000, Shandong, China.

Published: March 2025


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

To address environmental challenges such as eutrophication caused by excessive phosphorus discharge and low resource utilization of solid waste, this study investigates the factors influencing the physical properties of ceramsite from solid waste (SW-ceramsite) through sintering method, and its adsorption performance. The results shown that under the optimal conditions of additive dosage 9 g/100 g mixture, sintering temperature 1100 °C, heating rate 10 °C/min, and holding time 5 min, the values of breaking and wear rates and void fraction were 0.35% and 69.6%, respectively. Grey relation analysis indicated that the additive dosage was the most influential factor, followed by sintering temperature and heating rate, with holding time being the least impact. The equilibrium adsorption capacity (q) of SW-ceramsite for phosphorus was 1.85 mg/g. The adsorption process was better described by the Freundlich adsorption isotherm, as well as by the pseudo-first-order and pseudo-second-order kinetic models, and was characterized as non-spontaneous and exothermic. After nine regeneration cycles, The q of SW-ceramsite decreased by only 0.185 mg/g, with a regeneration loss rate was just 4.988%, suggesting good reusability. The findings suggest that the SW-ceramsite holds promise for treatment of phosphorus-containing wastewater.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11929828PMC
http://dx.doi.org/10.1038/s41598-025-94780-xDOI Listing

Publication Analysis

Top Keywords

solid waste
8
additive dosage
8
sintering temperature
8
heating rate
8
holding time
8
sw-ceramsite
5
study preparation
4
preparation mechanism
4
mechanism dephosphorization
4
dephosphorization sw-ceramsite
4

Similar Publications

CYP72A15 confers resistance against penoxsulam to Echinochloa phyllopogon.

Pestic Biochem Physiol

November 2025

Shenyang Agricultural University, College of Plant Protection, Shenyang, Liaoning 110866, PR China. Electronic address:

As the weed Echinochloa phyllopogon has rapidly developed multi- and cross-resistance to several herbicides, we aimed to determine the mechanism underlying penoxsulam resistance in weeds. There was no target mutation in the tested population, and P450 enzyme activity was significantly higher in the penoxsulam-treated resistant population, confirming that non-target-site resistance was dominant. The antioxidant enzyme activity of the resistant population was higher than that of the sensitive population following the application of the penoxsulam and cleared HO faster.

View Article and Find Full Text PDF

Phosphogypsum and Carbide Slag Synergy for Red Mud Soil Stabilization: Mechanical Performance, Environmental Impacts, and Micro-scale Mechanisms.

Environ Res

September 2025

China Construction Fourth Engineering Bureau Fifth Construction Engineering Co., Ltd. Nanxin Road, Nanshan District, Shenzhen, 518000, China. Electronic address:

The production of phosphogypsum (PG), calcium carbide slag (CS), and red mud (RM) in global industrial development imposes serious environmental issues. Utilizing CS and PG as curing agents and incorporating RM as a soil substitute can facilitate the solid waste resource utilization. However, few studies have investigated the synergistic effects of PG and CS on the stabilization of RM and soil.

View Article and Find Full Text PDF

Preparation of iron-rich belite-sulfoaluminate cement utilizing iron tailings and fluorogypsum.

Environ Res

September 2025

Key Laboratory of Green Utilization of Critical Non-metallic Mineral Resources, Ministry of Education, Wuhan University of Technology, Wuhan, Hubei 430070, China; School of Resources and Environmental Engineering, Wuhan University of Technology, Wuhan, Hubei 430070, China. Electronic address: yubiao

In order to promote the development and application of low-carbon cement varieties and the recycling of industrial solid waste, this study used iron tailings and fluorogypsum to prepare iron-rich belite-sulfoaluminate cement (I-BCSA). The suitable conditions for the preparation of I-BCSA in this system were with an excessive addition of 6 wt% of SO in the raw meal, at a calcination temperature of 1250 °C for 1.5 h, and an added-gypsum content of 15 wt%.

View Article and Find Full Text PDF

The disposal of municipal solid waste incineration fly ashes (MSWI-FA) is complicated by soluble chlorides, which increase the risk of heavy metals (HMs) leaching toxicity and hinder the further use of remediated MSWI-FA. In this study, the self-assembly potentiality of magnesium oxychloride cement (MOC) in geopolymerization was explored and utilized to enhance the solidification/stabilization (S/S) of the MSWI-FA. The MOC-self-assembled geopolymerization kinetics can be suitably described by the JMAK model.

View Article and Find Full Text PDF

Chemical alteration of UO micro-particles in model lung systems.

J Hazard Mater

August 2025

Radiochemistry Unit, Department of Chemistry, The University of Helsinki, Helsinki 00560, Finland. Electronic address:

Uranium dioxide (UO) particles can be released from mines, nuclear fuel manufacturing, reactor accidents, and weapons use. They pose inhalation risks, yet their behavior in the human lung remains poorly understood. This study investigates the long-term chemical alteration and dissolution of µm-sized UO particles in two model lung fluids: Simulated Lung Fluid (SLF) and Artificial Lysosomal Fluid (ALF), representing extracellular and intracellular lung environments, respectively.

View Article and Find Full Text PDF