Cyclic CO absorption/desorption property of LiNaSiO under the partial pressure of CO for practical applications.

Dalton Trans

Department of Physics, College of Humanities and Sciences, Nihon University, Setagaya-ku, Tokyo 156-8550, Japan.

Published: April 2024


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

The temperature for realizing the cyclic CO absorption/desorption property of LiNaSiO by repetition of switching a CO/N gas mixture and N with a partial pressure of CO, (CO), of 0.1 bar was optimized using the pseudo van't Hoff plot of LiNaCO + LiSiO ↔ LiNaSiO + CO prepared by thermogravimetry at various (CO) values.

Download full-text PDF

Source
http://dx.doi.org/10.1039/d4dt00212aDOI Listing

Publication Analysis

Top Keywords

cyclic absorption/desorption
8
absorption/desorption property
8
property linasio
8
partial pressure
8
linasio partial
4
pressure practical
4
practical applications
4
applications temperature
4
temperature realizing
4
realizing cyclic
4

Similar Publications

The effects of non-stoichiometric Mn and Cr on the hydrogen storage properties of Ti-Mn-based TiZrMn CrFe ( = 0, 0.1, 0.2) and TiZrMnCr Fe ( = 0, 0.

View Article and Find Full Text PDF

CO capture using mixed amines: experimental DFT investigation with focus on improvements in cyclic efficiency and NO interference.

Environ Sci Pollut Res Int

May 2025

Pakistan Council of Scientific and Industrial Research Complex Peshawar, Peshawar, Pakistan.

Post-combustion CO capture offers a promising solution for reducing carbon from power plants and marine emissions. By capturing CO from exhaust gases, it helps lessen the environmental impact. This paper evaluates the comparative performance of a hybrid blend of such absorbents as N-methyldiethanolamine (MDEA), ethanolamine (MEA), tetraethylenepentamine (TEPA), aminomethylpropanol (AMP), and piperazine (PZ) for CO capture, with emphasis on imitations of the flue gases for a marine engine.

View Article and Find Full Text PDF

Unleashing Superior Hydrogen Storage of Magnesium Hydride via Vanadium-Doped Bimetallic MXene.

Inorg Chem

April 2025

Collaborative Innovation Center of Coal Work Safety and Clean High Efficiency Utilization, Henan Key Laboratory of Coal Green Conversion, College of Chemistry and Chemical Engineering, Henan Polytechnic University, Jiaozuo 454000, China.

Magnesium hydride (MgH) has been recognized as a promising hydrogen storage material because of its low cost and high hydrogen capacity. However, the sluggish kinetics and high operating temperature hindered its utilization. Herein, vanadium-substituted titanium-based bimetallic MXene (TiVC) was prepared to boost the hydrogen storage efficiency of MgH.

View Article and Find Full Text PDF

Hydrogen storage and safe transport are the most important factors for hydrogen energy applications. Hydrogen has the necessary potential to provide clean fuel for heating and transportation because its only combustion product is pure water. Hydrogen is identified as one of the most renewable energy sources.

View Article and Find Full Text PDF

The growing demand for electronic storage devices with faster charging rates, higher energy capacities, and longer cycle lives has led to significant advancements in supercapacitor technology. These devices typically utilize high-surface-area carbon-based materials as electrodes, which provide excellent power densities and cycling stability. However, challenges such as inadequate electrolyte interaction, hydrophobicity that impedes ion transport, and high manufacturing costs restrict their effectiveness.

View Article and Find Full Text PDF