Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

The utilization of mid-infrared (mid-IR) light spanning the 3-5 µm range presents notable merits over the 1.5 µm band when operating in adverse atmospheric conditions. Consequently, it emerges as a promising prospect for serving as optical carriers in free-space communication (FSO) through atmospheric channels. However, due to the insufficient performance level of devices in the mid-IR band, the capability of mid-IR communication is hindered in terms of transmission capacity and signal format. In this study, we conduct experimental investigations on the transmission of time-domain multiplexed ultra-short optical pulse streams, with a pulse width of 1.8 ps and a data rate of up to 40 Gbps at 3.6 µm, based on the difference frequency generation (DFG) effect. The mid-IR transmitter realizes an effective wavelength conversion of optical time division multiplexing (OTDM) signals from 1.5 µm to 3.6 µm, and the obtained power of the 40 Gbps mid-IR OTDM signal at the optimum temperature of 54.8 °C is 7.4 dBm. The mid-IR receiver successfully achieves the regeneration of the 40 Gbps 1.5 µm OTDM signal, and the corresponding regenerated power at the optimum temperature of 51.5 °C is -30.56 dBm. Detailed results pertaining to the demodulation of regeneration 1.5 µm OTDM signal have been acquired, encompassing parameters such as pulse waveform diagram, bit error rate (BER), and Q factor. The estimated power penalty of the 40 Gbps mid-IR OTDM transmission is 2.4 dB at a BER of 1E-6, compared with the back-to-back (BTB) transmission. Moreover, it is feasible by using chirped PPLN crystals with wider bandwidth to increase the data rate to the order of one hundred gigabits.

Download full-text PDF

Source
http://dx.doi.org/10.1364/OE.497175DOI Listing

Publication Analysis

Top Keywords

otdm signal
12
optical pulse
8
pulse streams
8
data rate
8
gbps mid-ir
8
mid-ir otdm
8
optimum temperature
8
15 µm otdm
8
mid-ir
7
otdm
5

Similar Publications

As a low-energy method to increase the data rate of optical links in data centers, we propose self-homodyne Nyquist optical time division multiplexing (OTDM). In Nyquist OTDM, spectrally efficient high-baud rate signals can be generated exceeding the limit of electronic signal processing. However, full integration of OTDM systems has not been reported, mainly because of the complicated signal detection scheme, which involves demultiplexing and clock recovery.

View Article and Find Full Text PDF

The utilization of mid-infrared (mid-IR) light spanning the 3-5 µm range presents notable merits over the 1.5 µm band when operating in adverse atmospheric conditions. Consequently, it emerges as a promising prospect for serving as optical carriers in free-space communication (FSO) through atmospheric channels.

View Article and Find Full Text PDF

Two-Channel OTDM System for Data-Center Interconnects: A Review.

Sensors (Basel)

June 2023

Department of Semiconductor Engineering, Seoul National University of Science and Technology, Seoul 01811, Republic of Korea.

It has been proposed to implement the >100 Gb/s data-center interconnects using a two-channel optical time-division multiplexed system with multilevel pulse-amplitude modulation. Unlike the conventional four-channel optical time-division multiplexed system which requires an expensive narrow pulse, the two-channel system can be implemented cost-effectively using a wide pulse (which can be simply generated using a single modulator). The two-channel system is expected to be practically available using an integrated transmitter in a chip due to the recent advances in photonics-integrated circuits.

View Article and Find Full Text PDF

In this work, we propose a chaotic secure communication system with optical time division multiplexing (OTDM), using two cascaded reservoir computing systems based on multi beams of chaotic polarization components emitted by four optically pumped VCSELs. Here, each level of reservoir layer includes four parallel reservoirs, and each parallel reservoir contains two sub-reservoirs. When the reservoirs in the first-level reservoir layer are well trained and the training errors are far less than 0.

View Article and Find Full Text PDF

To improve the transmission capacity of an optical system, different multiplexing schemes have been proposed, such as optical time division multiplexing (OTDM), wavelength division multiplexing (WDM), polarization division multiplexing (PolDM), spatial division multiplexing (SDM), etc. One kind of SDM technique to boost the capacity is through modifying the spatial phase structure of an optical beam, which is known as the orbital angular momentum (OAM) division multiplexing. Moreover, the OAM signal emitter can be produced by using mature and high-yield silicon photonic (SiPh) technology, without the need of using bulky optical components or expensive spatial light modulator (SLM).

View Article and Find Full Text PDF