Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Dogs () prefer the walk at lower speeds and the more economical trot at speeds ranging from 0.5 Fr up to 3 Fr. Important works have helped to understand these gaits at the levels of the center of mass, joint mechanics, and muscular control. However, less is known about the global dynamics for limbs and if these are gait or breed-specific. For walk and trot, we analyzed dogs' global dynamics, based on motion capture and single leg kinetic data, recorded from treadmill locomotion of French Bulldog ( = 4), Whippet ( = 5), Malinois ( = 4), and Beagle ( = 5). Dogs' pelvic and thoracic axial leg functions combined compliance with leg lengthening. Thoracic limbs were stiffer than the pelvic limbs and absorbed energy in the scapulothoracic joint. Dogs' ground reaction forces (GRF) formed two virtual pivot points (VPP) during walk and trot each. One emerged for the thoracic (fore) limbs (VPP) and is roughly located above and caudally to the scapulothoracic joint. The second is located roughly above and cranially to the hip joint (VPP). The positions of VPPs and the patterns of the limbs' axial and tangential projections of the GRF were gaits but not always breeds-related. When they existed, breed-related changes were mainly exposed by the French Bulldog. During trot, positions of the VPPs tended to be closer to the hip joint or the scapulothoracic joint, and variability between and within breeds lessened compared to walk. In some dogs, VPP was located below the pelvis during trot. Further analyses revealed that leg length and not breed may better explain differences in the vertical position of VPP or the horizontal position of VPP. The vertical position of VPP was only influenced by gait, while the horizontal position of VPP was not breed or gait-related. Accordingly, torque profiles in the scapulothoracic joint were likely between breeds while hip torque profiles were size-related. In dogs, gait and leg length are likely the main VPPs positions' predictors. Thus, variations of VPP positions may follow a reduction of limb work. Stability issues need to be addressed in further studies.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10360120PMC
http://dx.doi.org/10.3389/fbioe.2023.1193177DOI Listing

Publication Analysis

Top Keywords

scapulothoracic joint
16
position vpp
16
global dynamics
12
vpp
9
pivot points
8
walk trot
8
french bulldog
8
hip joint
8
vpp positions
8
positions vpps
8

Similar Publications

The normal functioning of the shoulder is characterized by the harmonious coordination between the glenohumeral joint and the scapulothoracic complex, a phenomenon commonly referred to as scapulohumeral rhythm (SHR). Reverse total shoulder arthroplasty (rTSA) shoulders exhibit distinct kinematics compared to normal shoulders. Reduced scapulohumeral rhythm (SHR) in rTSA shoulders implies a greater reliance on scapulothoracic motion over glenohumeral motion for arm elevation.

View Article and Find Full Text PDF

Scapular kinematics and task specificity: The effect of load direction.

J Biomech

October 2025

Department of Mechanical and Materials Engineering, Queen's University, 130 Stuart St., Kingston, ON K7L 2V9, Canada. Electronic address:

Our current understanding of healthy scapula motion is mainly based on studying the shoulder when it is generating an abduction torque against gravity. However, the shoulder can perform diverse tasks beyond abduction. In particular, little attention has been given to how scapula motion contributes to concentric adduction despite its involvement in high-demand tasks such as rock climbing and wheelchair transfers.

View Article and Find Full Text PDF

Introduction: The shoulder joint complex is prone to musculoskeletal issues, such as rotator cuff-related pain, which affect two-thirds of adults and often result in suboptimal treatment outcomes. Current musculoskeletal models used to understand shoulder biomechanics are limited by challenges in personalization, inaccuracies in predicting joint and muscle loads, and an inability to simulate anatomically accurate motions. To address these deficiencies, we developed a novel, personalized modeling framework capable of calibrating subject-specific joint centers and functional axes for the shoulder complex.

View Article and Find Full Text PDF

Medial Approach Derotational Humeral Osteotomy in Patients with Brachial Plexus Birth Palsy.

JBJS Essent Surg Tech

August 2025

Division of Hand and Reconstructive Microsurgery, Department of Orthopedics, Olympia Hospital & Research Centre, Trichy, Tamilnadu, India.

Background: Medial-approach derotational humeral osteotomy is indicated in patients with brachial plexus birth palsy (BPBP) who have internal rotation contracture, a condition that substantially limits upper-extremity function and creates cosmetic concerns as a result of excessive internal rotation. This procedure enhances the range of motion of the arm by surgically externally rotating the humerus, thereby facilitating essential activities such as bringing the hand to the mouth and neck without the need for compensatory movements. In addition, the medial approach offers cosmetic benefits; the incision along the inner arm is less conspicuous than those of traditional lateral approaches.

View Article and Find Full Text PDF

Case: This case report describes a rare low-energy extrathoracic scapular dislocation, from axial loading of the upper extremity, in the setting of previous glenohumeral arthrodesis. By 4 months after closed reduction, the patient's scapulothoracic joint felt stable and his neurologic symptoms had returned to baseline. Over a seventeen-month follow-up period, he did not sustain a recurrent dislocation.

View Article and Find Full Text PDF