Category Ranking
98%
Total Visits
921
Avg Visit Duration
2 minutes
Citations
20
Article Abstract
A LiPO nanocoating around a nickel-rich cathode material was successfully constructed controlling the reaction between the electrode material and a preformed phosphorus-containing polymeric nanoshell; this not only effectively tackles the alkali residue challenge, but it also contributes to much-improved electrochemical performance being shown by a high-energy cathode.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1039/d1cc06131c | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Effects of CuO Deposition on Cracked TiO Nanoflower Photoanodes in Dye-Sensitized Solar Cells.
Langmuir
September 2025
Microelectronics & Nanotechnology-Shamsuddin Research Centre (MiNT-SRC), Universiti Tun Hussein Onn Malaysia, Batu Pahat 86400 Johor, Malaysia.
Achieving a crack-free, high-surface-area photoanode is essential for maximizing the efficiency of dye-sensitized solar cells (DSSCs). In this work, rutile titanium dioxide (rTiO) nanoflowers were synthesized hydrothermally and then conformally coated with copper(I) oxide (CuO) by RF magnetron sputtering to seal pre-existing cracks and to create a nanothorn surface favorable for dye adsorption. Systematic control of the sputtering time identified 60 min as optimal condition, yielding a photoanode thickness of about 6.
View Article and Find Full Text PDFAdvanced nitrogen-doped transition metal oxides decorated with Pt: synthesis and composition strategies for maximised electrochemical performance.
Dalton Trans
September 2025
University of Belgrade, Faculty of Physical Chemistry, Studentski trg 12-16, 11158 Belgrade, Serbia.
Developing efficient, low-cost catalysts for oxygen reduction and evolution reactions (ORR and OER) is key to advancing metal-air batteries and regenerative fuel cells. In this study, nitrogen-doped binary metal (Mn and Ni) oxides (N-BMOs) and Pt-decorated N-BMOs were synthesised using three methods and tested as ORR and OER catalysts in alkaline media. Their physicochemical properties were characterised by XRD, N-sorption, TEM, and XPS, while their electrochemical performance was evaluated using voltammetry and impedance spectroscopy.
View Article and Find Full Text PDFAntiferroelectric SnO Network with Amorphous Surface for Electrochemical N Fixation.
Angew Chem Int Ed Engl
September 2025
State Key Laboratory of Bioinspired Interfacial Materials Science, Bioinspired Science Innovation Center, Hangzhou International Innovation Institute, Beihang University, Hangzhou, 311115, China.
Electrochemical nitrogen fixation-a sustainable pathway for converting abundant N into NH using renewable energy-holds transformative potential for revolutionizing artificial nitrogen cycles. Nevertheless, even the state-of-the-art catalytic systems also suffer from inadequate N adsorption capacity, which critically limits ammonia production rates and Faradaic efficiency (FE). To overcome this bottleneck, we strategically leveraged the antiferroelectric properties of SnO to establish dipole-dipole interactions with N molecules, synergistically enhancing both N adsorption and activation kinetics.
View Article and Find Full Text PDFCo-doping aluminum and boron enhances the stability and electrochemical properties of nickel-rich cathode materials for lithium-ion batteries.
Dalton Trans
September 2025
School of Education, Can Tho University, 3-2 Road, Can Tho City 900000, Vietnam.
Enhancement of the performance of lithium-ion batteries is a critical strategy for addressing the challenges associated with cost and raw materials. By doping boron (B), aluminum (Al), and aluminum/boron (Al/B) utilizing the sol-gel method, we demonstrate a substantial improvement in the cycling performance of Ni-rich lithium nickel manganese cobalt oxide (NMC) as an electrode. While the initial specific capacitance of the doped samples may be lower than that of the pristine NMC, these samples demonstrate a notable increase in specific capacitance during subsequent cycles, reaching a peak around the 10 cycle and nearing the highest specific capacitance observed in NMC cathodes.
View Article and Find Full Text PDFDurable Superhydrophobic Bilayer Coating for Carbon Steel with Integrated Corrosion Resistance and Anti-icing Performance.
Langmuir
September 2025
Institute of Technology for Carbon Neutralization, Yangzhou University, Yangzhou 225127, Jiangsu, China.
To expand the application scope of carbon steel, imparting superhydrophobicity to its surface offers an effective strategy to overcome its inherently poor corrosion resistance. However, in marine environments, conventional superhydrophobic coatings often suffer from limited mechanical durability and inadequate long-term corrosion protection. In this study, a durable superhydrophobic bilayer coating composed of PDMS-MWCNTs (top layer) and PDMS (bottom layer) was developed to address these challenges.
View Article and Find Full Text PDF