98%
921
2 minutes
20
The purpose of this consensus document was to develop feasible, evidence-based occupational heat safety recommendations to protect the US workers that experience heat stress. Heat safety recommendations were created to protect worker health and to avoid productivity losses associated with occupational heat stress. Recommendations were tailored to be utilized by safety managers, industrial hygienists, and the employers who bear responsibility for implementing heat safety plans. An interdisciplinary roundtable comprised of 51 experts was assembled to create a narrative review summarizing current data and gaps in knowledge within eight heat safety topics: (a) heat hygiene, (b) hydration, (c) heat acclimatization, (d) environmental monitoring, (e) physiological monitoring, (f) body cooling, (g) textiles and personal protective gear, and (h) emergency action plan implementation. The consensus-based recommendations for each topic were created using the Delphi method and evaluated based on scientific evidence, feasibility, and clarity. The current document presents 40 occupational heat safety recommendations across all eight topics. Establishing these recommendations will help organizations and employers create effective heat safety plans for their workplaces, address factors that limit the implementation of heat safety best-practices and protect worker health and productivity.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8388206 | PMC |
http://dx.doi.org/10.1029/2021GH000443 | DOI Listing |
Med Acupunct
August 2025
Acupuncture Service, Pain Management Centre, Sengkang General Hospital, Singapore, Singapore.
Background: Any injury to the diabetic limbs may portent disastrous consequences. However, it is not uncommon for diabetics to also seek complementary and alternative medicine for treatment, such as acupuncture. There are limited data on infective or ulcerative adverse events regarding acupuncture in diabetic limbs.
View Article and Find Full Text PDFFront Nutr
August 2025
College of Food Science and Technology, Yangzhou University, Yangzhou, Jiangsu, China.
Introduction: Fermented buffalo milk products from South Asia remain an underexplored source of microbial diversity with potential health-promoting benefits. This study investigates the probiotic and industrial suitability of lactic acid bacteria (LAB) and non-LAB isolates from traditional Pakistani dairy, addressing gaps in region-specific probiotic discovery.
Methods: Forty-seven bacterial isolates were obtained from fermented buffalo milk products (yogurt and cheese).
Food Prot Trends
June 2025
Dept. of Food, Nutrition, and Packaging Sciences, 220 Poole Agriculture Center, Clemson University, Clemson, SC 29634, USA.
Surface sanitation is used to mitigate the transmission of infectious agents and is the collective process of washing a surface then rinsing it with potable water to remove debris and residual cleaning agent. If necessary and depending on surface type, contamination event, or regulatory requirement, an antimicrobial agent (chemical sanitizer or disinfectant) registered with the Environmental Protection Agency or heat (steam or hot water) can be applied to the surface to reduce or inactivate pathogenic microorganisms. The absence of universally defined terms and regulations pertaining to the various stages of surface sanitation has resulted in confusion, potentially leading to inadequate sanitation practices and persistent surface contamination.
View Article and Find Full Text PDFTemperature (Austin)
June 2025
Department of Mechanical Engineering, Eindhoven University of Technology, Eindhoven, The Netherlands.
Sweating is a vital thermoregulatory mechanism in humans for maintaining thermal balance during exercise and exposure to hot environments. The development of models that predict sweat rate based on body temperature has been ongoing for over half a century. Here, we compared predicted water loss rates (WLR) from these models to actual observations collected during 780 participant-exposures in three independent laboratory-based experiments.
View Article and Find Full Text PDFPhys Chem Chem Phys
September 2025
School of Chemistry and Chemical Engineering, Nanjing University of Science and Technology, Nanjing, 210094, China.
To analyse the issues of high muzzle flame intensity and the easy migration of insensitive agents in conventional insensitive propellants, this study synthesizes modified nitrocellulose grafted with carboxymethyl potassium groups by a two-step process, starting from the molecular structure of nitrocellulose (NC), the principal component of propellants. First, the denitration reaction was performed to reduce part of the nitrate ester groups on the surface of NC to hydroxyl groups, followed by an etherification reaction to achieve directional grafting of carboxymethyl potassium groups. Compared with conventional flame retardant/insensitive systems based on nitrogen, phosphorus, or DBP (dibutyl phthalate), potassium-based functional groups exhibit superior thermal stability and environmental friendliness.
View Article and Find Full Text PDF