A Facile and Effective Ozone Exposure Method for Wettability and Energy-Level Tuning of Hole-Transporting Layers in Lead-Free Tin Perovskite Solar Cells.

ACS Appl Mater Interfaces

SKKU Advanced Institute of Nanotechnology (SAINT) and Department of Nano Engineering, Sungkyunkwan University (SKKU), Suwon 16419, Republic of Korea.

Published: September 2021


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Lead-free perovskite solar cells (PSCs) have attracted interest among scientists searching for eco-friendly energy harvesting devices. Herein, the effects of ozone exposure on poly(3,4-ethylenedioxythiophene) polystyrene sulfonate (PEDOT:PSS) in lead-free tin halide PSCs as a facile and low-cost process for improving device performance are analyzed. Two types of tin-based PSCs and one typical lead-based PSC were fabricated. The ozone exposure on PEDOT:PSS increases the short-circuit current density () and the fill factor (FF) of PSCs in all cases with perovskite grain enlargement and hole-mobility enhancement of the devices, respectively. For open-circuit voltage (), the outcome depends on the band gap and the energy levels of the perovskite films. While ozone exposure treatment is favorable for PEAFASnI-based tin PSCs, decreases with ozone exposure in the case of Ge:EDAFASnI-based tin PSCs because of a misalignment of the energy levels. Regardless, the efficiency of PEAFASnI-based tin PSCs increases from 8.7 to 10.1% when measured inside a glovebox upon ozone exposure of PEDOT:PSS. The efficiency of Ge:EDAFASnI-based tin PSCs increases from 6.8 to 8.1%, and the devices retain an efficiency of 5.0% even after 50 days in air.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acsami.1c13546DOI Listing

Publication Analysis

Top Keywords

ozone exposure
24
tin pscs
16
lead-free tin
8
perovskite solar
8
solar cells
8
pscs
8
exposure pedotpss
8
energy levels
8
peafasni-based tin
8
geedafasni-based tin
8

Similar Publications

Sulfate Promotes Amine Salt Ozonation in Atmospheric Aerosols.

J Am Chem Soc

September 2025

Guangdong-Hong Kong-Macao Joint Laboratory for Contaminants Exposure and Health, Guangdong Key Laboratory of Environmental Catalysis and Health Risk Control, Institute of Environmental Health and Pollution Control, Guangdong University of Technology, Guangzhou 510006, China.

Low molecular weight amines promote sulfate (SO and HSO) formation through acid-base reactions, contributing to fine particulate matter (PM). Heterogeneous ozonation converts nontoxic amine salts into highly toxic products, yet the ozonation activation mechanism is unclear. This work reveals a sulfate-dominant ozonation mechanism of amine salts in fine PM by combining advanced mass spectrometry and ab initio calculation methods.

View Article and Find Full Text PDF

Computational modeling for PPE filtration: Informed by material characterization, microbial penetration, and particle mechanics.

J Occup Environ Hyg

September 2025

Division of Biology, Chemistry, and Materials Science, Office of Science and Engineering Laboratories, US Food and Drug Administration (FDA), Oak Ridge, Tennessee.

This work assesses the current characterization framework of single-use personal protective equipment (PPE) per recognized consensus standards and presents a novel quantitative approach to refining characterization of barrier materials and predicting PPE performance. Scanning electron microscopy (SEM) and image analysis software (Diameter J) were used to examine the microscopic fiber and pore structure of filter layers of surgical N95 filtering facepiece respirators, before and after exposure to chemicals used in decontamination modalities (vaporized hydrogen peroxide or ozone). The effect of porosity on penetration was assessed by bacterial filtration efficiency (BFE) testing.

View Article and Find Full Text PDF

The role of personal protective equipment (PPE) in protecting against exposure to infectious agents and toxic chemicals is well-established. However, the global surge in PPE demand during the pandemic exposed challenges, including shortages and environmental impacts from disposable waste. Developing effective, scalable, and sustainable decontamination methods for the reuse of PPE is essential.

View Article and Find Full Text PDF

Wastewater as a dual indicator of human and environmental exposure to synthetic antioxidants: Occurrence and fate in biological and advanced wastewater treatment.

Environ Int

August 2025

Eawag: Swiss Federal Institute of Aquatic Science and Technology, Ueberlandstrasse 133, 8600, Duebendorf, Switzerland; Institute of Biogeochemistry and Pollutant Dynamics, Universitaetstrasse 16, 8092, Zurich, Switzerland. Electronic address:

Synthetic antioxidants (SAOs) are widely used additives in industrial and consumer products, yet their human exposure and fate throughout wastewater treatment remain poorly understood. This study investigates the occurrence of SAOs and their human metabolites in wastewater influent as well as their abatement in three wastewater treatment plants (WWTPs) employing both conventional and advanced treatment technologies. In vitro human liver S9 assays were performed to generate a SAO metabolite MS2 library containing over 2500 potential metabolites, which was matched against wastewater influent data.

View Article and Find Full Text PDF

Air pollution and diseases: signaling, G protein-coupled and Toll like receptors.

Pharmacol Ther

September 2025

Department of Molecular Pharmacology, University of Groningen, Groningen, the Netherlands; Groningen Research Institute for Asthma and COPD, GRIAC, University Medical Center Groningen, University of Groningen, Groningen, the Netherlands. Electronic address:

Air pollution is a significant public health issue that impacts lung health, particularly in vulnerable populations such as children, the elderly, and individuals with pre-existing respiratory conditions. Both natural and anthropogenic sources of air pollution give rise to a variety of toxic compounds, including particulate matter (PM), ozone (O₃), sulfur dioxide (SO₂), nitrogen dioxide (NO₂), carbon monoxide (CO), and polycyclic aromatic hydrocarbons (PAHs). Exposure to these pollutants is strongly associated with the development and exacerbation of respiratory diseases, including asthma, chronic obstructive pulmonary disease (COPD), lung cancer, and idiopathic pulmonary fibrosis (IPF).

View Article and Find Full Text PDF