Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

The purpose of this study was to investigate the comfort of aircraft passengers during long flights and to determine the effects of the seatback angle and the seat pitch on passengers' upper body muscles (neck, shoulder, and lower back) and subjective comfort. All subjects sat on an aircraft seat for 2 h with different levels of seatback angle and seat pitch. Subjective discomfort scores and root mean square (RMS) and mean power frequency (MPF) values were used to evaluate muscle fatigue, and all data were calculated for every 15-min interval. Significant increases of MPF for all three muscles were found at 30 min, along with significant increases in the perceived levels of discomfort (PLD) over 2 h. Besides, a 120° seatback angle and a 34˝ seat pitch resulted in lower PLD values for the lower back and hip areas than smaller ones (significant difference). It took around 30 min before pronounced discomfort in the upper body regions occurred during flight. The larger parameters of seatback angle and seat pitch may significantly contribute to the easing of subjective discomfort. Moreover, a decrease in MPF coupled with a concomitant increase in RMS does not appear to be a reliable indicator of discomfort rate. The need for further development of discomfort indicators which are more directly related to muscular activation is recognized.

Download full-text PDF

Source
http://dx.doi.org/10.3357/AMHP.5201.2020DOI Listing

Publication Analysis

Top Keywords

seatback angle
16
seat pitch
16
angle seat
12
long flights
8
upper body
8
subjective discomfort
8
discomfort
7
seat
5
aircraft passenger
4
passenger comfort
4

Similar Publications

Lap belt-induced Iliac Wing Fracture Risk Curve Development for Female PMHS in Frontal Sled Tests.

Ann Biomed Eng

August 2025

Medical College of Wisconsin, 5000 West National Ave, Research 151, Zablocki VA Medical Center, Milwaukee, WI, 53295, USA.

Purpose: This study estimates the tolerance of the female pelvis iliac wing under lap belt loading in frontal impacts. With future autonomous vehicles relying on seatbelts as the primary restraint, understanding pelvic injury biomechanics is crucial. The goal was to investigate pelvis fracture patterns resulting from seat belt loading among female specimens in MCW series and develop injury risk curves (IRCs) for iliac bone fracture.

View Article and Find Full Text PDF

Investigation of lumbar injury in out-of-position occupants via seat back angles under AES.

Comput Methods Biomech Biomed Engin

July 2025

Tianjin Key Laboratory of Microgravity and Hypogravity Environment Simulation Technology, Tianjin Institute of Aerospace Mechanical and Electrical Equipment, Tianjin, China.

The effects of seatback recline angles and occupant displacement during emergency steering maneuvers on lumbar injury trends were investigated. A collision simulation environment was created using the AC-HUM model combined with a partial vehicle model. Under varying seatback recline configurations, two pre-collision scenarios were simulated: with and without autonomous emergency steering (AES) intervention.

View Article and Find Full Text PDF

Objective: Testing was conducted to evaluate the performance of the THOR-50M for Reclined Seating (THOR-50M-RS) with modifications to allow for a more realistic posture and impact response under reclined seating conditions. Results were compared to tests conducted with PMHS under the same conditions.

Methods: Nine frontal sled tests were conducted using the THOR-50M-RS in a controlled response seat with the seatback angle set to 45 degrees.

View Article and Find Full Text PDF

This study explored differences in activities and spine kinematics by transient low back pain status throughout a week of their usual office work. Using a 100-mm visual-analogue scale, twenty participants were classified as non-pain (NPD) and pain developers (PD; ≥10 mm). Tri-axial accelerometers measured sitting time and thorax, pelvis, and lumbar spine angles.

View Article and Find Full Text PDF

Reclined postures in vehicle seats have received increasing attention due to vehicle automation, but research using current seats may not be applicable. Furthermore, published recommendations for longitudinal seat back contour in automotive seats are difficult to apply to seat design due to insufficient information concerning reference points and contours. To address these gaps, a laboratory study was conducted with a specially constructed seat with a seat back pivot coincident with the seat H-point.

View Article and Find Full Text PDF