Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Jinsha (JSH) is one of the regional background sites in Central China. In this study, eight polybrominated diphenyl ethers (PBDEs) were measured in atmospheric deposition samples (dry particle, wet particle, and wet dissolved), air (gaseous and particle) samples, and soil samples that were collected from March 2012 to March 2013. Of all eight PBDEs, BDE-209 was the most abundant congener in both deposition samples and air/soil samples. Average dry particle, wet particle, and wet dissolved deposition fluxes of ΣPBDEs were 270 ± 310 pg m day, 130 ± 210 pg m day, and 250 ± 330 pg m day, respectively, while those of BDE-209 were 210 ± 290 pg m day, 80 ± 120 pg m day, and 160 ± 290 pg m day, respectively. Dry deposition velocities of individual PBDE ranged from 0.11 ± 0.15 cm s (BDE-183) to 0.24 ± 0.38 cm s (BDE-209), and total washout ratios ranged from 5.0 × 10 (BDE-28) to 4.2 × 10 (BDE-209). The calculated net air-soil gas exchange flux of ΣPBDEs was - 16 ± 13 pg m day, suggesting the deposition status of PBDEs. The gas exchange flux at the air-soil interface was significantly lower than the deposition flux, which only accounted for 2.5% of the total deposition flux, implying that atmospheric deposition was an important input pathway for PBDEs to soils. Overall, the pollution level of the soil was relatively low, and the soil serves as a sink for PBDEs from adjacent regions.

Download full-text PDF

Source
http://dx.doi.org/10.1007/s11356-019-06312-6DOI Listing

Publication Analysis

Top Keywords

particle wet
16
atmospheric deposition
12
polybrominated diphenyl
8
diphenyl ethers
8
ethers pbdes
8
central china
8
deposition
8
deposition samples
8
dry particle
8
wet particle
8

Similar Publications

Sub-150 nm drug nanocrystals produced using a milligram-scale media mill.

Int J Pharm

September 2025

School of Pharmacy, Queen's University Belfast, 97 Lisburn Road, Belfast BT9 7BL, United Kingdom. Electronic address:

Nanocrystals (NCs), nano-sized drug particles, offer a promising strategy to enhance the bioavailability of poorly soluble compounds, a challenge that affects 70-90 % of new chemical entities. Among the available production methods, wet media milling is widely adopted due to its scalability and efficiency. However, conventional lab-scale mills often require large suspension volumes and high amounts of drug, limiting their suitability for early-stage development, particularly with novel or scarce compounds.

View Article and Find Full Text PDF

Phosphogypsum is an acidic solid waste mainly composed of CaSO₄-2H₂O by-products of the wet process phosphoric acid industry, which has the characteristics of high impurity content, poor stability of stockpiling, but can be utilized in a resourceful way. Phosphogypsum waste utilization can reduce environmental pollution, save resources and create economic value. In order to investigate the fatigue characteristics and the mechanism of dynamic strength change of cement-phosphogypsum-red clay under wet and dry cycles, the cumulative deformation characteristics and the rule of change of critical dynamic stress of the mixed materials were investigated by dynamic triaxial fatigue test, SEM and XRD test, and the mechanism of dynamic strength change was analyzed according to the microstructure and the chemical mineral composition of the mixed materials.

View Article and Find Full Text PDF

The overlooked pathway: A systematic review on sewage sludge treatment as a critical secondary source of terrestrial micro(nano)plastics.

Sci Total Environ

September 2025

Jiangsu Key Laboratory of Atmospheric Environment Monitoring and Pollution Control, School of Environmental Science and Engineering, Nanjing University of Information Science and Technology, Nanjing 210044, China. Electronic address:

Sewage sludge has long been believed as an essential sink for microplastics (MPs), with concentrations up to 1380 particles/kg dry weight. Considering that MP residues in present sewage sludge are predominantly aged, their surface characteristics have been modified, with specific surface area ranging from 1 m/g to 5 m/g and a carbonyl index increasing from 0.2 to 1.

View Article and Find Full Text PDF

ObjectiveThis study aims to assess the concentration and removal efficiency of microplastics (MPs) at a major wastewater treatment plant in Jordan, a region with limited data on MP pollution.MethodsA field-based experimental study was conducted. Grab samples of 14 L were collected from both influent and effluent streams on a single sampling day.

View Article and Find Full Text PDF

Traditional dust removal technologies have relatively low capture efficiencies for PM2.5 (particulate matter ≤2.5 μm) emitted by coal-fired power plants.

View Article and Find Full Text PDF