Performance evaluation of quantitative SPECT/CT using NEMA NU 2 PET methodology.

Phys Med Biol

Faculty of Health Sciences, University of Sydney, Lidcombe, NSW, Australia. Author to whom any correspondence should be addressed.

Published: July 2019


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Although PET is routinely evaluated using NEMA NU2 as standard in the clinic, standard methodology for evaluating the performance of quantitative SPECT systems has not been established. In this study, the quantitative performance of the Symbia Intevo SPECT/CT was evaluated for two common isotopes (Tc, Lu) and benchmarked against the performance of a PET/CT. A further aim was to demonstrate the utility of adapting NEMA NU2 PET measurements to SPECT. In addition, dead-time and resolution recovery were evaluated to provide more complete system evaluations. Spatial resolution of the SPECT system at 1 cm from the center in the transverse direction was 13.1 mm and 22.4 mm for Tc and Lu respectively, compared with 4.3 mm (F) and 5.8 mm (Ga) for PET. Sensitivity at the center of the FoV was 119 cps MBq and 48 cps MBq (Tc, Lu) for SPECT and 9632 cps MBq and 8216 cps MBq (F, Ga) for PET. Scatter fraction was 0.25 and 0.36 (Tc, Lu) for SPECT and 0.32 and 0.29 (F, Ga) for PET. Contrast recovery coefficient in the largest spheres was 0.79 and 0.65 (Tc, Lu) for SPECT, 1.00 and 0.97 (F, Ga) for PET and the background variability was 2.7%, 6.5% (Tc, Lu), 1.5% and 1.6% (F, Ga), respectively. Partial volume effect was evaluated using the NEMA IQ phantom with six sphere inserts (diameter: 37 mm, 28 mm, 22 mm, 17 mm, 13 mm and 10 mm). Full contrast recovery was reached with the 17 mm for F, while SPECT did not reach full recovery for any sphere. Count rate losses were 2% for Tc at 1 GBq and 11% for Lu at 8.5 GBq which are well below the typical activities for clinical applications. We concluded NEMA NU2 methodology can be easily adapted to SPECT/CT as a routine quality assurance procedure in the clinic.

Download full-text PDF

Source
http://dx.doi.org/10.1088/1361-6560/ab2a22DOI Listing

Publication Analysis

Top Keywords

cps mbq
16
nema nu2
12
evaluated nema
8
contrast recovery
8
pet
7
spect
7
nema
5
performance
4
performance evaluation
4
evaluation quantitative
4

Similar Publications

Introduction/aim: Terbium-161 (Tb) has emerged as a promising therapeutic radionuclide, yet standardized imaging guidelines are lacking. This study aimed to characterize a SPECT/CT system, currently used in an ongoing clinical trial (BETA PLUS; NCT05359146), focusing on sensitivity, septal penetration, and dead-time effects.

Methods: Measurements were conducted on a Siemens Symbia Intevo system using two collimators: low-energy high-resolution (LEHR) and medium-energy low-penetration (MELP).

View Article and Find Full Text PDF

Purpose: In single-photon emission computed tomography (SPECT), the standardized uptake value requires a becquerel calibration factor (BCF). The changes over time in BCF due to different radionuclides and collimators was examined.

Methods: The BCF (cps/MBq) was monthly calculated from the radioactivity of syringe formulations and dispensed sources measured with a dose calibrator, and planar acquisition counts.

View Article and Find Full Text PDF

Accurate determination of ultratrace plutonium isotopes (Pu, Pu, Pu, and Pu) generally requires the utilization of multiple techniques. Among them, alpha spectrometry is the only way to measure ultratrace Pu (<1 mBq/1.6 fg) but with a very long counting time (hours to days).

View Article and Find Full Text PDF

/ Lutetium-177 is a widely used radioisotope in targeted radionuclide therapy, particularly for treating certain types of cancers relying on beta and low-energy gamma emissions, making it suitable for both therapeutic and post-therapy monitoring purposes. The purpose of this study was to evaluate the technical parameters for developing a prototype portable gamma camera dedicated to Lu imaging applications. : The well-validated GATE Monte Carlo toolkit was used to study the characteristics of the system and evaluate its performance in terms of spatial resolution, sensitivity, and image quality.

View Article and Find Full Text PDF

Purpose: EasyPET.3D is a preclinical positron emission tomography (PET) scanner with a unique scanning method based on two face-to-face detector modules with two axes of motion. Its performance evaluation is presented using the NEMA NU-4 standards and an animal model.

View Article and Find Full Text PDF