Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

This work is dedicated to study the potential application of char byproducts obtained in the gasification of rice husk (RG char) and rice husk blended with corn cob (RCG char) as removal agents of two emergent aquatic contaminants: tetracycline and caffeine. The chars presented high ash contents (59.5-81.5%), being their mineral content mainly composed of silicon (as silica) and potassium. The samples presented a strong basic character, which was related to its higher mineral oxides content. RCG char presented better textural properties with a higher apparent surface area (144 m g) and higher micropore content (V  = 0.05 cm g). The alkaline character of both chars promoted high ecotoxicity levels on their aqueous eluates; however, the ecotoxic behaviour was eliminated after pH correction. Adsorption experiments showed that RG char presented higher uptake capacity for both tetracycline (12.9 mg g) and caffeine (8.0 mg g), indicating that textural properties did not play a major role in the adsorption process. For tetracycline, the underlying adsorption mechanism was complexation or ion exchange reactions with the mineral elements of chars. The higher affinity of RG char to caffeine was associated with the higher alkaline character presented by this char.

Download full-text PDF

Source
http://dx.doi.org/10.1007/s11356-017-9938-9DOI Listing

Publication Analysis

Top Keywords

rice husk
8
rcg char
8
char presented
8
textural properties
8
alkaline character
8
char
7
higher
6
presented
5
study removal
4
removal mechanism
4

Similar Publications

In this study, a silicon carbide (SiC) mixed-matrix membrane for oil-water separation was successfully fabricated within the nanofiltration range. Silicon carbide was synthesized using rice husk ash (RHA), an agricultural waste material, combined with polydimethylsiloxane (PDMS) and subsequently incorporated into a mixed matrix membrane for oil-water separation. Polysulfone (PSF) and polyvinylpyrrolidone (PVP) were employed as polymer supports for fabricating the SiC-based mixed matrix membrane, which was tested in a dead-end filtration setup.

View Article and Find Full Text PDF

This study investigates the effects of pyrolytic temperature and feedstock type on the release of biochar-derived dissolved organic matter (BDOM) and its impact on the soil bacterial community and the composition of soil dissolved organic matter (SDOM). The BDOM was extracted from biochars produced from sheep bones, rice husk, and rabbit manure, prepared at low (400 °C, LPT) or high (700 °C, HPT) pyrolytic temperatures. The BDOM was then applied at a concentration of 2.

View Article and Find Full Text PDF

The efficient handling of agricultural waste is rapidly gaining worldwide recognition. This study analyzes the impact of three distinct pyrolysis temperatures (250, 300, and 350 °C) on the physicochemical properties of the biochar produced from rice husk, sugarcane bagasse, and groundnut shells with a fixed pyrolysis time of 3 h. The influence of the pyrolysis temperature was assessed by calculating the biochar yield, electrical conductivity (EC), pH, proximate analysis, and ultimate analysis.

View Article and Find Full Text PDF

Sustainable Rice Husk Ash-Tannin Xerogel for Ciprofloxacin Removal from Water.

Environ Res

August 2025

International Research Centre of Nanotechnology for Himalayan Sustainability (IRCNHS), Shoolini University, Solan 173229, India; Institute for Interdisciplinary and Innovation Research, Xi'an University of Architecture and Technology, Xi'an 710055, P.R. China. Electronic address: gaurav.541@shooloni

This research investigates the synthesis and application of a bioderived xerogel (BDX) synthesized from rice husk and tannins to eliminate Ciprofloxacin (CIP) from water-based media. Xerogel was prepared via sol-gel method, incorporating rice husk ash and tannin extract, along with polyvinyl alcohol (PVA) as a binding agent. Characterization techniques including, FTIR (Fourier Transform Infrared Spectroscopy), XRD (X-ray Diffraction), SEM (Scanning Electron Microscopy), AFM (Atomic Force Microscopy), TGA (Thermogravimetric Analysis), and BET (Brunauer-Emmett-Teller) surface area analysis were employed to evaluate its structural and chemical properties.

View Article and Find Full Text PDF

Sol-Gel-Derived Silica/Alumina Particles for Enhancing the Mechanical Properties of Acrylate Composite Materials.

Gels

July 2025

Department of Chemical Dynamics and Permanent Education, VINČA Institute of Nuclear Sciences-National Institute of the Republic of Serbia, University of Belgrade, 11351 Belgrade, Serbia.

Silica/alumina composite particles were synthesized via the sol-gel method to promote fine dispersion and homogenous mixing. Aluminum chloride hydroxide served as the alumina precursor, while amorphous silica, obtained from rice husk, was directly incorporated into the alumina sol. Following synthesis, the material was calcined at 1000 °C, yielding an α-cristobalite form of silica and corundum-phase alumina.

View Article and Find Full Text PDF