Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Ruthenium oxide (RuO) is the best oxygen evolution reaction (OER) electrocatalyst. Herein, we demonstrated that RuO can be also efficiently used as an oxygen reduction reaction (ORR) electrocatalyst, thereby serving as a bifunctional material for rechargeable Zn-air batteries. We found two forms of RuO (i.e. hydrous and anhydrous, respectively h-RuO and ah-RuO) to show different ORR and OER electrocatalytic characteristics. Thus, h-RuO required large ORR overpotentials, although it completed the ORR via a 4e process. In contrast, h-RuO triggered the OER at lower overpotentials at the expense of showing very unstable electrocatalytic activity. To capitalize on the advantages of h-RuO while improving its drawbacks, we designed a unique structure (RuO@C) where h-RuO nanoparticles were embedded in a carbon matrix. A double hydrophilic block copolymer-templated ruthenium precursor was transformed into RuO nanoparticles upon formation of the carbon matrix via annealing. The carbon matrix allowed overcoming the limitations of h-RuO by improving its poor conductivity and protecting the catalyst from dissolution during OER. The bifunctional RuO@C catalyst demonstrated a very low potential gap (ΔE  = ca. 1.0 V) at 20 mA cm. The Zn||RuO@C cell showed an excellent stability (i.e. no overpotential was observed after more than 40 h).

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC5540911PMC
http://dx.doi.org/10.1038/s41598-017-07259-9DOI Listing

Publication Analysis

Top Keywords

carbon matrix
16
embedded carbon
8
h-ruo improving
8
h-ruo
6
ruo
5
bifunctional hydrous
4
hydrous ruo
4
ruo nanocluster
4
nanocluster electrocatalyst
4
electrocatalyst embedded
4

Similar Publications

Deep Learning-Assisted Organogel Pressure Sensor for Alphabet Recognition and Bio-Mechanical Motion Monitoring.

Nanomicro Lett

September 2025

Nanomaterials & System Lab, Major of Mechatronics Engineering, Faculty of Applied Energy System, Jeju National University, Jeju, 63243, Republic of Korea.

Wearable sensors integrated with deep learning techniques have the potential to revolutionize seamless human-machine interfaces for real-time health monitoring, clinical diagnosis, and robotic applications. Nevertheless, it remains a critical challenge to simultaneously achieve desirable mechanical and electrical performance along with biocompatibility, adhesion, self-healing, and environmental robustness with excellent sensing metrics. Herein, we report a multifunctional, anti-freezing, self-adhesive, and self-healable organogel pressure sensor composed of cobalt nanoparticle encapsulated nitrogen-doped carbon nanotubes (CoN CNT) embedded in a polyvinyl alcohol-gelatin (PVA/GLE) matrix.

View Article and Find Full Text PDF

The rapid emergence of mineralized structures in diverse animal groups during the late Ediacaran and early Cambrian periods likely resulted from modifications of pre-adapted biomineralization genes inherited from a common ancestor. As the oldest extant phylum with mineralized structures, sponges are key to understanding animal biomineralization. Yet, the biomineralization process in sponges, particularly in forming spicules, is not well understood.

View Article and Find Full Text PDF

Asymmetric Electronic Distribution at Mn-Cu Dual Atomic Sites Promoting Electrochemical Conversion of N to NH.

Angew Chem Int Ed Engl

September 2025

State Key Laboratory of Analytical Chemistry for Life Science, School of Chemistry and Chemical Engineering, Nanjing University, Nanjing, 210023, China.

Electrochemical synthesis of ammonia (NH) is a promising green alternative to the conventional Haber-Bosch process. Here, we report the synthesis of a heteroatomic metal-metal bonded dual atomic (DA) Mn-Cu catalytic site embedded within nitrogen-doped carbon (NC) matrix for high-performance electrochemical reduction of N to NH. The asymmetric electronic distribution localized at the dual atomic sites synergistically enhances the adsorption and activation of N, facilitating the complex proton-coupled electron transfer process.

View Article and Find Full Text PDF

With the rapid advancement in autonomous vehicles, 5G and future 6G communications, medical imaging, spacecraft, and stealth fighter jets, the frequency range of electromagnetic waves continues to expand, making electromagnetic interference (EMI) shielding a critical challenge for ensuring the safe operation of equipment. Although some existing EMI shielding materials offer lightweight construction, high strength, and effective shielding, they struggle to efficiently absorb broadband electromagnetic waves and mitigate dimensional instability and thermal stress caused by temperature fluctuations. These limitations significantly reduce their service life and restrict their practical applications.

View Article and Find Full Text PDF

Peptide Sequence Modulating the Analytical Performance of Electrogenerated Chemiluminescence Peptide-Based Biosensors for Matrix Metalloproteinase 2.

Anal Chem

September 2025

Key Laboratory of Analytical Chemistry for Life Science of Shaanxi Province, School of Chemistry and Chemical Engineering, Shaanxi Normal University, Xi'an 710062, P. R. China.

Electrogenerated chemiluminescence (ECL) methods have been widely used in clinical diagnosis. Although ECL peptide-based biosensors continue to grow with good sensitivity and signal flexibility, little emphasis has been placed on the effect of the peptide sequence on ECL sensitivity. We herein studied the nuanced effects of different peptide sequences on the analytical performance of ECL peptide-based biosensors for matrix metalloproteinase 2 (MMP-2) assay, in which [(pbz)Ir(DMSO)Cl] (pbz = 3-(2-pyridyl)benzoic acid) was used as the ECL emitter while a specific peptide was used as the molecular recognition element.

View Article and Find Full Text PDF