98%
921
2 minutes
20
Objective: The quality and radiation dose of different tube voltage sets for chest digital radiography (DR) were compared in a series of pediatric age groups.
Materials And Methods: Forty-five hundred children aged 0-14 years (yr) were randomly divided into four groups according to the tube voltage protocols for chest DR: lower kilovoltage potential (kVp) (A), intermediate kVp (B), and higher kVp (C) groups, and the fixed high kVp group (controls). The results were analyzed among five different age groups (0-1 yr, 1-3 yr, 3-7 yr, 7-11 yr and 11-14 yr). The dose area product (DAP) and visual grading analysis score (VGAS) were determined and compared by using one-way analysis of variance.
Results: The mean DAP of protocol C was significantly lower as compared with protocols A, B and controls (p < 0.05). DAP was higher in protocol A than the controls (p <0.001), but it was not statistically significantly different between B and the controls (p = 0.976). Mean VGAS was lower in the controls than all three protocols (p < 0.001 for all). Mean VGAS did not differ between protocols A and B (p = 0.334), but was lower in protocol C than A (p = 0.008) and B (p = 0.049).
Conclusion: Protocol C (higher kVp) may help optimize the trade-off between radiation dose and image quality, and it may be acceptable for use in a pediatric age group from these results.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3542296 | PMC |
http://dx.doi.org/10.3348/kjr.2013.14.1.126 | DOI Listing |
Radiat Prot Dosimetry
September 2025
Department of Radiological Science, Faculty of Health Sciences, Junshin Gakuen University, 1-1-1 Chikushigaoka, Minami-ku, Fukuoka, 815-8510, Japan.
In radiological imaging, much research has been conducted on tube voltage and additional filters to reduce radiation exposure. In this study, the usefulness of heavy metal filters in lumbar spine imaging to maintain image quality and reduce radiation dose was investigated. A human-body phantom was irradiated with various combinations of tube voltages (70, 75, 80, 85, and 90 kV) and filters (Cu, Gd, Ho, Yb, W).
View Article and Find Full Text PDFMed Phys
August 2025
Division of X-Ray Imaging and CT, German Cancer Research Center (DKFZ), Heidelberg, Germany.
Background: The optimal tube voltage in clinical CT depends on the patient's attenuation and the imaging task. Although the patient's attenuation changes with view angle and longitudinal position of the X-ray tube, the tube voltage remains constant throughout the scan in current clinical practice. In general, the optimum tube voltage increases with patient diameter.
View Article and Find Full Text PDFNat Commun
August 2025
Department of Physics, Stockholm University, AlbaNova University Center, Stockholm, Sweden.
Cascade multiplication is widely used to enhance photon detector sensitivity. While vacuum tube and semiconductor photomultipliers achieve high gains in the optical range, their performance at lower frequencies is limited by large work functions. Superconducting detectors overcome this constraint, enabling operation in the terahertz (THz) and microwave (MW) ranges.
View Article and Find Full Text PDFJ Nanobiotechnology
August 2025
State Key Laboratory of Oral & Maxillofacial Reconstruction and Regeneration, Shaanxi Key Laboratory of Stomatology, Department of Prosthodontics, School of Stomatology, National Clinical Research Center for Oral Diseases, The Fourth Military Medical University, Xi'an, 710032, Shaanxi, China. songwe
The regulatory role of migrasomes (Migs) has attracted growing attentions recently. However, most of the reports only focus on the influence of donor cells on Migs contents, regarding the substrate information. In the present study, the bone marrow mesenchymal stem cells (BMSCs) derived Migs were investigated on titania micropits/nanotubes (MNT) under different anodization voltages.
View Article and Find Full Text PDFSci Rep
August 2025
Institute of Theoretical and Applied Mechanics, Czech Academy of Sciences, Prosecka 809/76, 190 00, Prague, Czech Republic.
In this work, an in-situ study of phase transitions in low-carbon steel is presented. The phase changes were monitored by the transmission energy dispersive X-ray diffraction technique during the heating, annealing and quenching cycle of the sample under standard laboratory conditions. During energy dispersive X-ray diffraction, the sample volume was transmitted with a pencil beam generated by a standard polychromatic X-ray tube without any spectral filtering.
View Article and Find Full Text PDF