98%
921
2 minutes
20
The distributions of sizes of silver nanoparticles that were deposited on monolayer, bilayer, and trilayer graphene films were observed. Deposition was carried out by thermal evaporation and the graphene films, placed on SiO2/Si substrates, were obtained by the mechanical splitting of graphite. Before the deposition, optical microscopy and Raman spectroscopy were utilized to identify the number of the graphene layers. After the deposition, scanning electron microscopy was used to observe the morphologies of the particles. Systematic analysis revealed that the average sizes of the nanoparticles increased with the number of graphene layers. The density of nanoparticles decreased as the number of graphene layers increased, revealing a large variation in the surface diffusion strength of nanoparticles on the different substrates. The mechanisms of formation of these layer-dependent morphologies of silver on n-layer graphene are related to the surface free energy and surface diffusion of the n-layer graphene. The effect of the substrate such as SiO2/Si was investigated by fabricating suspended graphene, and the size and density were similar to those of supported graphene. Based on a comparison of the results, the different morphologies of the silver nanoparticles on different graphene layers were theorized to be caused only by the variation of the diffusion barriers with the number of layers of graphene.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3507757 | PMC |
http://dx.doi.org/10.1186/1556-276X-7-618 | DOI Listing |
ACS Nano
September 2025
Eastern Institute for Advanced Study, Eastern Institute of Technology, Ningbo, Zhejiang 315200, P. R. China.
Ni-Fe (oxy)hydroxides are among the most active oxygen evolution reaction (OER) catalysts in alkaline media. However, achieving precise control over local asymmetric Fe-O-Ni active sites in Ni-Fe oxyhydroxides for key oxygenated intermediates' adsorption steric configuration regulation of the OER is still challenging. Herein, we report a two-step dealloying strategy to fabricate asymmetric Fe-O-Ni pair sites in the shell of NiOOH@FeOOH/NiOOH heterostructures from NiFe Prussian blue analogue (PBA) nanocubes, involving anion exchange and structure reconstruction.
View Article and Find Full Text PDFLangmuir
September 2025
Product & Process Engineering, Department of Chemical Engineering, Faculty of Applied Sciences, Delft University of Technology, 2629 HZ Delft, The Netherlands.
Noble metal nanoparticles (NPs), particularly platinum (Pt), are widely used in heterogeneous catalysis due to their exceptional activity. However, controlling their size and preventing sintering during synthesis remains a major challenge, especially when aiming for high dispersion and stability on supports such as graphene. Atomic layer deposition (ALD) has emerged as a promising method to address these issues, yet conventional processes often lead to broad particle size distributions (PSDs).
View Article and Find Full Text PDFJ Phys Chem B
September 2025
National Key Laboratory of Solid Rocket Propulsion, Northwestern Polytechnical University, Xi'an 710072, China.
Hexaazaisowurtzitane (CL-20) is a high-energy-density compound with poor thermal stability, which hinders its application in composite energetic systems. A bi-interface structure of polydopamine-coated graphene oxide (GO@PDA) is shown to markedly improve thermal stability compared with pristine CL-20 and single-layer coatings. Reactive molecular dynamics simulations enhanced by a neural network potential (NNP) reveal that the delayed onset of decomposition arises from suppressed NO release and altered spatial density distribution, while interfacial -OH and -COOH groups consume intermediates, redirect decomposition pathways, and inhibit autocatalytic chain reactions.
View Article and Find Full Text PDFACS Nano
September 2025
State Key Laboratory of Flexible Electronics (LoFE) & Institute of Advanced Materials (IAM), Nanjing University of Posts & Telecommunications, 9 Wenyuan Road, Nanjing 210023, China.
Bimorph soft actuators, traditionally composed of two materials with distinct responses to external stimuli, often face durability challenges due to structural incompatibility. Here, we propose an alternative design employing free-standing, isostructural heterogeneous Janus (IHJ) films that harmonize stability with high actuation efficiency. These IHJ films were fabricated through a vacuum self-assembly process, consisting of TiCT MXene nanosheets and hybrid graphene oxide (GO)-biomass bacterial cellulose (BC), with a well-matched two-dimensional lattice structure.
View Article and Find Full Text PDFACS Omega
September 2025
Institute of Physics, University of Brasília, Brasília, Federal District 70910-900, Brazil.
The exploration of three-dimensional (3D) carbon allotropes has received increasing attention due to their potential in advanced materials and nanotechnology. Irida-Graphene (IG), a two-dimensional carbon allotrope with a structure consisting of 3-6-8 carbon rings, can be used as a precursor for creating 3D materials with tailored properties. This work presents a comprehensive computational characterization of four novel 3D structures derived from IG, named 3D-IG-α, -β, -γ, and -δ.
View Article and Find Full Text PDF