Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

On May 2009, both the gas and particulate fractions of smoke from a wildfire in Sever do Vouga, central Portugal, were sampled. Total hydrocarbons and carbon oxides (CO(2) and CO) were measured using automatic analysers with flame ionisation and non-dispersive infrared detectors, respectively. Fine (PM(2.5)) and coarse (PM(2.5-10)) particles from the smoke plume were analysed by a thermal-optical transmission technique to determine the elemental and organic carbon (EC and OC) content. Subsequently, the particle samples were solvent extracted and fractionated by vacuum flash chromatography into different classes of organic compounds. The detailed organic speciation was performed by gas chromatography-mass spectrometry. The CO, CO(2) and total hydrocarbon emission factors (g kg(-1) dry fuel) were 170 ± 83, 1485 ± 147, and 9.8 ± 0.90, respectively. It was observed that the particulate matter and OC emissions are significantly enhanced under smouldering fire conditions. The aerosol emissions were dominated by fine particles whose mass was mainly composed of organic constituents, such as degradation products from biopolymers (e.g. levoglucosan from cellulose, methoxyphenols from lignin). The compound classes also included homologous series (n-alkanes, n-alkenes, n-alkanoic acids and n-alkanols), monosaccharide derivatives from cellulose, steroid and terpenoid biomarkers, and polycyclic aromatic hydrocarbons (PAHs). The most abundant PAH was retene. Even carbon number homologs of monoglycerides were identified for the first time as biomarkers in biomass burning aerosols.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.scitotenv.2010.12.025DOI Listing

Publication Analysis

Top Keywords

organic
5
emission trace
4
trace gases
4
gases organic
4
organic components
4
components smoke
4
smoke particles
4
particles wildfire
4
wildfire mixed-evergreen
4
mixed-evergreen forest
4

Similar Publications

Thioesterification of Polyfluoroarenes via Copper-Catalyzed Radical Cross-Coupling with KS and Aldehydes in Water.

Org Lett

September 2025

College of Materials and Chemical Engineering, Key Laboratory of Inorganic Nonmetallic Crystalline and Energy Conversion Materials, China Three Gorges University, Yichang, Hubei 443002, P. R. China.

A novel copper-catalyzed radical cross-coupling reaction for the thioesterification of polyfluoroarenes is developed using KS and aldehydes in water. This protocol employs a readily available KS as a sulfur source, eliminating the need for hazardous thiols and organic solvents. The mild reaction conditions are compatible with a wide range of functional groups, providing access to diverse polyfluoroaryl thioesters.

View Article and Find Full Text PDF

Tuning the Electrical Property and Electronic Band Structures of Organic Semiconductors via Surface Tension.

J Phys Chem Lett

September 2025

National Laboratory of Solid-State Microstructures, School of Electronic Science and Engineering, Collaborative Innovation Center of Advanced Microstructures, Nanjing University, Nanjing 210093, P. R. China.

Stress engineering is an effective way to tune the performance of semiconductors, which has been verified in the work of inorganic and organic single-crystal semiconductors. However, due to the limitations of the vapor-phase growth preparation conditions, the deposited polycrystalline organic semiconductors are more susceptible to residual stress. Therefore, it is of great research significance to develop a low-cost stress engineering applicable to vapor-deposited semiconductors.

View Article and Find Full Text PDF

To address the increasingly limited water availability, using metal-organic frameworks (MOFs) to capture atmospheric water vapor as usable resources has emerged as a promising strategy. The adsorption characteristics of MOFs as well as their step pressure (i.e.

View Article and Find Full Text PDF

Cardiovascular diseases (CVDs) remain a leading cause of death, particularly in developing countries, where their incidence continues to rise. Traditional CVD diagnostic methods are often time-consuming and inconvenient, necessitating more efficient alternatives. Rapid and accurate measurement of cardiac biomarkers released into body fluids is critical for early detection, timely intervention, and improved patient outcomes.

View Article and Find Full Text PDF

Bisphenol A (BPA) is a persistent organic pollutant with toxic effects on human health and ecosystems. In this study, the performance of MWCNT-OH functionalized with iron nanoparticles (MWCNT-OH@Fe) using sugarcane bagasse extract as a reducing agent (green synthesis) was evaluated for BPA adsorption. The kinetics are fast, between 10 and 20 min in the range of concentrations evaluated and the resistance to external film diffusion (external film mass transfer) identified as the rate-limiting step of the process.

View Article and Find Full Text PDF