98%
921
2 minutes
20
In a pot experiment Ricinus communis plants were cultivated in quartz sand and supplied daily with a nutrient solution which contained 4 mol m(-3) nitrate as the nitrogen source and either full strength potassium (1.3 mol m(-3), control) or 8% potassium (0.1 mol m(-3), K(+)-limitation). Although the final fresh weight of the whole plant was not affected by K(+)-limitation, the root-shoot ratio was increased due to a relatively increased root growth and inhibited development of younger shoot parts. Owing to K(+)-limitation, photosynthesis was slightly decreased, while dark respiration of the shoot markedly decreased and root respiration was nearly doubled. The transport of carbon in the phloem, and to some extent in the xylem, was greater and the root was favoured in the partitioning of carbon. This was also true for nitrogen and potassium which were both taken up at lower rates, particularly potassium. In these two cases a high remobilization and recycling from the old part of the shoot was observed. By contrast, uptake of sodium was 2.4-fold higher under K(+)-limitation and this resulted in increased flows in the plants, which was discussed generally as a means for charge balance (in combination with a slight increase in uptake of magnesium and calcium). Nitrate reduction took place in the same portion in the root and shoot. This was a shift to the root compared to the control and points to an inhibition of xylem transport caused by limitation of K(+) as an easily permeating countercation. Low K(+) supply also resulted in an increased biosynthesis of ABA in the roots (265%). This caused a slightly increased deposition of ABA in the roots (193%) and a 4.6-fold higher root-to-shoot and a doubled shoot-to-root ABA signal in the xylem or phloem, respectively. The high degradation of ABA in the shoots prevented ABA accumulation there.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1093/jexbot/53.367.241 | DOI Listing |
RSC Adv
August 2025
Department of Chemistry, Faculty of Forestry and Wood Technology, Poznan University of Life Sciences Wojska Polskiego 28 60-637 Poznań Poland.
This study aims to evaluate the application potential of unrefined vegetable oils derived from three plant species- (), (), and rapeseed ( L. var. )-as renewable raw materials for the synthesis of bio-based polyurethane foams.
View Article and Find Full Text PDFWater Res
August 2025
Department of Environmental Engineering, Chung Yuan Christian University, Taoyuan 32023, Taiwan, ROC; Center for Environmental Risk Management, Chung Yuan Christian University, Taoyuan 32023, Taiwan, ROC. Electronic address:
This study investigates the application of magnetite (FeO) and polyaniline (PANI)-functionalized PVDF membranes in anaerobic membrane bioreactors (AnMBRs) for fouling mitigation and bioenergy recovery. Four membranes (PVDF, PANI/PVDF, FeO/PVDF, and FeO@PANI/PVDF) were evaluated over 250 days at fluxes of 2, 4, and 6 LMH. Modified membranes significantly reduced early-stage fouling, with FeO@PANI/PVDF achieving the lowest rate (0.
View Article and Find Full Text PDFInt J Biol Macromol
August 2025
National Engineering Research Center of Novel Equipment for Polymer Processing, Guangdong Provincial Key Laboratory of Technique and Equipment for Macromolecular Advanced Manufacturing, School of Mechanical & Automotive Engineering, South China University of Technology, Guangzhou, Guangdong 510640,
Plastic pollution remains a pressing global concern, driving demand for biodegradable, renewable alternatives to petroleum-based plastics. Starch is an abundant and low-cost material; however, mechanical deficiencies and degradation during conventional shear-based processing hinder its utilization. We now present a novel processing strategy utilizing an eccentric rotor extruder (ERE) that generates continuous volumetric elongational flow with minimal shear.
View Article and Find Full Text PDFACS Omega
August 2025
School of Management Science and Engineering, Shandong Technology and Business University, Yantai 264005, China.
This study presents a comprehensive application of integrated machine learning tools for modeling and optimizing the ibuprofen synthesis process. Initially, a database of 39,460 input combinations is created using chemical reaction theory and validated with experimental data. The CatBoost meta-model, optimized by the snow ablation optimizer, outperforms conventional algorithms in predicting reaction time, conversion rate, and production cost.
View Article and Find Full Text PDFRapid Commun Mass Spectrom
November 2025
Department of Chemistry and Biochemistry, University of Windsor, Windsor, Ontario, Canada.
Rationale: Hydrogen sulfide (HS) sulfur stable isotope ratio (δS) analyses use cadmium (Cd) or zinc (Zn) solutions; however, Cd is toxic, and Zn does not display an obvious change in color at low molar HS inputs. This study (i) developed a non-toxic, colorimetric mixed zinc/silver (Zn/Ag)-based method and (ii) evaluated the minimum HS input required for analysis.
Methods: Gaseous HS was trapped using the Cd- and Zn/Ag-based methods and converted to solid silver sulfide (AgS).