Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Background: Acromioclavicular joint (ACJ) dislocations have been linked to altered scapulothoracic orientation and scapula dyskinesis, but research on three-dimensional (3D) changes in scapulothoracic orientation after such injury in vivo has not been described before. The aim of our pilot study was to analyze scapulothoracic orientation changes in patients with ACJ dislocations using three-dimensional computed tomographic (CT) image reconstruction.

Methods: Patients with ACJ dislocations who underwent CT imaging were included retrospectively and consecutively. Minors and cases with spine, neurologic or systemic diseases, and shoulder girdle fractures were excluded. Each CT was performed in supine position with elbows rested on the scanning table and had to depict the complete shoulder girdle. After 3D image reconstruction, tilt, upward rotation, internal rotation, translation, and protraction of the scapula were measured based on three osseous landmarks: the glenoid (the deepest point of its concavity), the medial root of the scapular spine, and the inferior scapular angle. The healthy contralateral side was used as a paired control. ACJ dislocations were graded according to Rockwood (RW) on strict frontal CT image reconstruction, including the contralateral shoulder, where measurements were also performed to enable comparison. Cases were labeled as acute or chronic with a 3-week injury-to-diagnosis interval cut-off.

Results: The mean age of the 14 patients (11 males and 3 females) was 38.6 ± 15.6 years (range, 18-71). Ten cases were defined as acute (RW types II: 1; III: 3; V: 6) and four as chronic (II: 1; III: 2; V: 1). On the injured side, the scapula showed more internal rotation (46.2° ± 5.3° vs. 42.1° ± 4.4°; = .003), more scapular tilt (20.2° ± 4.6° vs. 17.9° ± 3.5°; = .022), and less upward rotation (10.1° ± 3.6° vs. 12.0° ± 4.8°; = .043). No difference between sides was found for scapular translation ( = .342) and scapular protraction ( = .385). There was a trend toward more internal rotation for RW type V injuries ( = .097).

Conclusion: In this first 3D in vivo study, patients with ACJ dislocations displayed changes in scapulothoracic orientation in all planes. The scapula of the injured side was more internally rotated, forwardly tilted, and less upwardly rotated than on the healthy contralateral side.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC12144983PMC
http://dx.doi.org/10.1016/j.jseint.2025.01.012DOI Listing

Publication Analysis

Top Keywords

scapulothoracic orientation
20
acj dislocations
20
changes scapulothoracic
12
patients acj
12
internal rotation
12
three-dimensional changes
8
acromioclavicular joint
8
shoulder girdle
8
image reconstruction
8
upward rotation
8

Similar Publications

The normal functioning of the shoulder is characterized by the harmonious coordination between the glenohumeral joint and the scapulothoracic complex, a phenomenon commonly referred to as scapulohumeral rhythm (SHR). Reverse total shoulder arthroplasty (rTSA) shoulders exhibit distinct kinematics compared to normal shoulders. Reduced scapulohumeral rhythm (SHR) in rTSA shoulders implies a greater reliance on scapulothoracic motion over glenohumeral motion for arm elevation.

View Article and Find Full Text PDF

Scapular kinematics and task specificity: The effect of load direction.

J Biomech

October 2025

Department of Mechanical and Materials Engineering, Queen's University, 130 Stuart St., Kingston, ON K7L 2V9, Canada. Electronic address:

Our current understanding of healthy scapula motion is mainly based on studying the shoulder when it is generating an abduction torque against gravity. However, the shoulder can perform diverse tasks beyond abduction. In particular, little attention has been given to how scapula motion contributes to concentric adduction despite its involvement in high-demand tasks such as rock climbing and wheelchair transfers.

View Article and Find Full Text PDF

Background: Acromioclavicular joint (ACJ) dislocations have been linked to altered scapulothoracic orientation and scapula dyskinesis, but research on three-dimensional (3D) changes in scapulothoracic orientation after such injury in vivo has not been described before. The aim of our pilot study was to analyze scapulothoracic orientation changes in patients with ACJ dislocations using three-dimensional computed tomographic (CT) image reconstruction.

Methods: Patients with ACJ dislocations who underwent CT imaging were included retrospectively and consecutively.

View Article and Find Full Text PDF

Background: Movement limitations following implantation of reverse total shoulder arthroplasty (rTSA) have been observed in some patients postoperatively, with implant design and positioning recognized as important influential factors. Recent analyses have identified patient's posture, measured as scapula internal rotation on computed tomography (CT), as an additional factor influencing the functional outcome after rTSA. However, no clinical study has correlated the preoperatively photo-documented posture to functional outcome.

View Article and Find Full Text PDF

Hypothesis: The primary objective of this study was to assess intraobserver repeatability and interobserver reproducibility of the 3-dimensional (3D) coordinates of a set of scapula anatomical landmarks obtained by manual positioning on conventional supine computed tomography (CT) scan-based scapula surface models. The secondary objective was to assess intraobserver repeatability and interobserver reproducibility of the resulting 3D scapular orientation. It was hypothesized that the 3D scapular orientation reliability would be better or similar than established reliability of intraoperative baseplate positioning (ie, version and inclination) in reverse total shoulder arthroplasty.

View Article and Find Full Text PDF