Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

A two-step annealing treatment was applied on a fully transparent amorphous InGaZnO4 (a-IGZO) top-gate thin-film transistor (TG-TFT) to improve the device performance. The electrical properties and stabilities of a-IGZO TG TFTs were significantly improved as the first-annealing temperature increased from 150 °C to 350 °C with a 300 °C second-annealing treatment. The a-IGZO TG-TFT with the 300 °C first-annealing treatment demonstrated the overall best performance, which has a mobility of 13.05 cm/(V·s), a threshold voltage () of 0.33 V, a subthreshold swing of 130 mV/dec, and a / of 1.73 × 10. The deviation (Δ) was -0.032 V and -0.044 V, respectively, after a 7200 s positive and negative bias stress under the gate bias voltage = ±3 V and = 0.1 V. The Photoluminescence spectra results revealed that the distribution and the density of defects in a-IGZO films were changed after the first-annealing treatment, whereas the X-ray photoelectron spectroscopy results displayed that contents of the oxygen vacancy and Ga-O bond varied in annealed a-IGZO films. In addition, a-IGZO TG-TFTs had achieved a transmittance of over 90%. Research on the effects of the first-annealing treatment will contribute to the fabrication of highly stable top-gate TFTs in the fields of transparent flexible electronics.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11946357PMC
http://dx.doi.org/10.3390/nano15060460DOI Listing

Publication Analysis

Top Keywords

first-annealing treatment
12
fully transparent
8
a-igzo top-gate
8
top-gate thin-film
8
two-step annealing
8
annealing treatment
8
300 °c
8
a-igzo films
8
a-igzo
7
treatment
6

Similar Publications

Enhancement in Performance and Reliability of Fully Transparent a-IGZO Top-Gate Thin-Film Transistors by a Two-Step Annealing Treatment.

Nanomaterials (Basel)

March 2025

Shandong Technology Center of Nanodevices and Integration, and School of Integrated Circuits, Shandong University, Jinan 250101, China.

A two-step annealing treatment was applied on a fully transparent amorphous InGaZnO4 (a-IGZO) top-gate thin-film transistor (TG-TFT) to improve the device performance. The electrical properties and stabilities of a-IGZO TG TFTs were significantly improved as the first-annealing temperature increased from 150 °C to 350 °C with a 300 °C second-annealing treatment. The a-IGZO TG-TFT with the 300 °C first-annealing treatment demonstrated the overall best performance, which has a mobility of 13.

View Article and Find Full Text PDF

CuZnSnSe (CZTSe) is a promising material for thin-film solar cells due to its suitable band gap, high absorption coefficient, and composition of earth-abundant and nontoxic elements. In this study, we prepared CZTSe thin films from Cu/SnSe and ZnSe stacks using a two-step annealing process. Initially, Cu-Sn-Se (CTSe) films were synthesized by sequential deposition and annealing of Cu and SnSe precursors in either a selenium (Se) or tin-selenium (Sn+Se) atmosphere.

View Article and Find Full Text PDF

It is generally recognized that high-temperature treatments, namely annealing, influence the microstructure and the morphology, which, in turn, determine the mechanical properties of polymeric parts. Therefore, annealing can be adopted to control the mechanical performance of the molded parts. This work aims to assess the effect of annealing on the morphology developed in isotactic polypropylene (iPP) injection-molded parts.

View Article and Find Full Text PDF

Reducing the graphene grain density in three steps.

Nanotechnology

March 2016

Graduate Institute of Opto-Mechatronics, National Chung Cheng University, 168 University Road, Min-Hsiung Township, Chiayi County 62102, Taiwan.

The production of large-scale, single crystalline graphene is a requirement for enhancing its electronic, mechanical, and chemical properties. Chemical vapor deposition (CVD) has shown the potential to grow high quality graphene but the simultaneous nucleation of many grains limits their achievable domain size. We report here that ultralow nucleation densities can be achieved through multi-step optimization of the catalyst morphology.

View Article and Find Full Text PDF