98%
921
2 minutes
20
Background: Oblique lumbar interbody fusion (OLIF) through a prepsoas approach was identified as an alternative to alleviate complications associated with direct lateral interbody fusion. Cage placement is known to influence cage subsidence and fusion rates due to suboptimal biomechanics. There are limited studies exploring cage obliquity as a potential factor influencing fusion outcomes. Hence, our objective was to assess the effects of cage obliquity and position on fusion rates, subsidence, and sagittal alignment in patients who underwent OLIF.
Methods: Patients who underwent OLIF for levels L1 to L5 in our center, performed by a single surgeon and with a minimum of 12 months of follow-up, were included in the study. Cage obliquity and sagittal placement were measured, and their correlation with fusion, subsidence, and sagittal alignment correction was assessed. Fusion and subsidence were evaluated using the Bridwell Criteria and Marchi Criteria, respectively.
Results: Among the included patients (age, 67.5 ± 7.93 years; 16 men and 37 women), 97 fusion levels were studied. The mean cage obliquity was 4.2° ± 2.8°. Ninety-six levels (99.0%) were considered to have achieved fusion with a Bridwell score of 1 or 2. Eighty-one (83.5%), 14 (14.4%), and 2 (2.06%) operated levels had a Marchi score of 0, 1, and 2, respectively. A Marchi grade of 1 or higher was considered indicative of significant subsidence. There was good improvement in both the segmental lordosis angle (4.2° ± 5.7°; < 0.0001) and disc height (4.5 ± 3.8 mm; < 0.0001). Cage placement did not have any statistical correlation with fusion rates, subsidence, or sagittal alignment.
Conclusions: Our results indicate that OLIF facilitates appropriate cage placement with only a minor degree of cage obliquity, typically less than 20°. This minor obliquity does not lead to lower fusion rates, increased subsidence, or sagittal malalignment. Despite subsidence being common, the majority of these cases resulted in complete fusion.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11616436 | PMC |
http://dx.doi.org/10.14444/8623 | DOI Listing |
Asian Spine J
August 2025
Department of Neurological Surgery, University of California, San Diego, San Diego, CA, USA.
Study Design: A single surgeon, retrospective case series.
Purpose: This study aimed to compare the radiological outcomes after using expandable versus static cages in oblique lumbar interbody fusion (OLIF).
Overview Of Literature: OLIF enables access to the spine while avoiding the anterior vessels and psoas muscles via a retroperitoneal corridor.
J Vis Exp
July 2025
Rehabilitation Research Institute of Singapore, Lee Kong Chian School of Medicine, Nanyang Technological University;
The surgical technique of L2- L5 Oblique Lumbar Interbody Fusion (OLIF), including the exposure of the surgical corridor, preparation of the disc space, and placement of the interbody cages, followed by pedicle screw fixation, is presented. To perform this technique, the patient is positioned in right lateral decubitus on a radiolucent table, and an oblique incision is made 3-5 cm anterior to the middle of the L3-L4 disc space. After dissecting the subcutaneous fat, the external oblique aponeurosis is cut along the line of the incision and the oblique muscles (external and internal), and the transversus abdominis muscles are split along the direction of the muscle fibers.
View Article and Find Full Text PDFKorean J Neurotrauma
July 2025
Department of Neurosurgery, Dong-A University Hospital, Dong-A University College of Medicine, Busan, Korea.
Objective: The oblique lateral interbody fusion (OLIF) technique at the L5-S1 segment can be approached via iliac vessel bifurcation or prepsoas approaches, depending on vascular anatomy and iliac crest height. This study aims to compare clinical and radiological outcomes between these two surgical methods.
Methods: This single-center retrospective study analyzed 58 patients undergoing OLIF surgery at L5-S1 from January 2020 to December 2023.
BMC Musculoskelet Disord
August 2025
Department of Orthopedic Surgery and Orthopedic Research Institute, West China Hospital, Sichuan University, Chengdu, Sichuan Province, 610041, China.
Background: Large contact areas between the grafted bone and the bony endplate (BEP) can optimize the load transmission pattern and decrease the risk of non-union and cage subsidence. The relationship between endplate morphology parameters and complications may stem from the difference in contact sufficiency between the grafted bone and BEP. This study was conducted to verify that changes in endplate morphology affect the risk of complications in patients with oblique lumbar interbody fusion (OLIF) by changing the grafted bony occupancy rate (GBOR).
View Article and Find Full Text PDFBMC Musculoskelet Disord
August 2025
Department of Orthopedics, Southwest Hospital, Army Medical University, Chongqing, 400038, Chongqing, China.
Background Context: Typical oblique lumbar interbody fusion (OLIF) generally employed either the single lateral screw (SLS) or dual pedicle screws (DPS) for instrumentation, each with their own limitations.
Purpose: The study aimed to investigate the biomechanical properties of two additional fixation strategies including single reverse pedicle screw (SRS) and dual overlapped screws (DOS) compared with SLS and DPS.
Study Design: A finite element (FE) analysis study.