98%
921
2 minutes
20
Introduction: A 56-hole porous tip radiofrequency catheter was developed to provide more uniform cooling with less fluid delivery than a prior 6-hole irrigated design. This study aimed to evaluate the impact of contact force (CF) ablation with the porous tip on complications (congestive heart failure [CHF] and non-CHF related), healthcare resource utilization, and procedural efficiency in patients undergoing de novo paroxysmal atrial fibrillation (PAF) ablations in a real-world setting.
Methods: Consecutive de novo PAF ablations were performed between February 2014 and March 2019 by six operators at a single US academic center. The 6-hole design was used through December 2016 with the 56-hole porous tip adopted in October 2016. The outcomes of interest included symptomatic CHF presentation and CHF-related complications.
Results: Of 174 patients who were included, mean age was 61.1 ± 10.8 years, 67.8% were male, and 25.3% had a history of CHF. Ablation with the porous tip catheter significantly decreased fluid delivery (1177 vs. 1912 mL with the 6-hole design; < .0001). CHF-related complications within 7 days, particularly fluid overload, were substantially reduced with the porous tip (15.2% vs. 5.3% of patients; .0281) and the proportion of patients with symptomatic CHF presentation within 30 days postablation was significantly lower (14.7% vs. 32.5%; .0058).
Conclusion: The 56-hole porous tip led to significantly reduced CHF-related complications and healthcare utilization in PAF patients undergoing CF catheter ablation when compared to the prior 6-hole design. This reduction likely results from the significant decrease in fluid delivery during the procedure.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10264747 | PMC |
http://dx.doi.org/10.1002/joa3.12830 | DOI Listing |
Adv Colloid Interface Sci
September 2025
Department of Civil and Environmental Engineering, University of Waterloo, Waterloo, Ontario N2L 3G1, Canada.
Conventional laboratory methods for measuring and determining fluid flow parameters often involve complexities and simplifications that can lead to inaccuracies. These limitations hinder a comprehensive understanding of fluid flow behavior in reservoirs. This study reviews the use of Magnetic Resonance Imaging (MRI) as a non-invasive technique to investigate key parameters governing fluid flow in porous media, such as capillary pressure and relative permeability.
View Article and Find Full Text PDFNanomaterials (Basel)
June 2024
Jožef Stefan Institute, Department of Surface Engineering, Teslova ulica 30, 1000 Ljubljana, Slovenia.
Carbon deposits consisting of vertically oriented multilayer graphene sheets on metallic foils represent an interesting alternative to activated carbon in electrical and electrochemical devices such as super-capacitors because of the superior electrical conductivity of graphene and huge surface-mass ratio. The graphene sheets were deposited on cobalt foils by plasma-enhanced chemical vapor deposition using propane as the carbon precursor. Plasma was sustained by an inductively coupled radiofrequency discharge in the H mode at a power of 500 W and a propane pressure of 17 Pa.
View Article and Find Full Text PDFAnal Chem
June 2024
NIMBE, CEA, CNRS, Université de Paris Saclay, CEA Saclay, 91191 Gif-sur-Yvette, France.
A simple, low-cost, and efficient device is proposed for the study of porous materials via NMR using small gas probes. Mainly built through additive manufacturing and being equipped with a radiofrequency solenoid microcoil, it only requires tiny quantities of sample and/or gas and is particularly suited for hyperpolarized xenon. The performances of this device have been accessed on a commercial sample of MCM-41 exhibiting multiporosity.
View Article and Find Full Text PDFJ Interv Card Electrophysiol
November 2024
Department of Cardiology, Nagoya University Graduate School of Medicine, 65 Tsurumai, Showa, Nagoya, Aichi, Nagoya, 466-8550, Japan.
Background: The TactiFlex SE catheter (TFSE, Abbott) with a contact force (CF) sensor and a laser-cut irrigated-tip has recently become available but lacks a lesion quality marker. This study aimed to explore distinctions in lesion characteristics between the TFSE and the ThermoCool SmartTouch SurroundFlow catheter (STSF, Biosense Webster), which utilizes a porous irrigated tip, and to assess the most effective application settings for the TFSE.
Methods: Lesions were generated using varying settings of radiofrequency power (30-50 W), CF (10-20 g), application duration (10-40 s), and catheter orientation (perpendicular or parallel) in an ex vivo porcine model.
Polymers (Basel)
March 2024
Centre of Polymer Systems, University Institute, Tomas Bata University in Zlín, Trida Tomase Bati 5678, 760 01 Zlin, Czech Republic.
This study involved the creation of highly porous PLA scaffolds through the porogen/leaching method, utilizing polyethylene glycol as a porogen with a 75% mass ratio. The outcome achieved a highly interconnected porous structure with a thickness of 25 μm. To activate the scaffold's surface and improve its hydrophilicity, radiofrequency (RF) air plasma treatment was employed.
View Article and Find Full Text PDF