Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Background: Cavovarus deformity of the hindfoot is typically caused by neurologic disorders. Multiple osteotomies have been described for the correction of varus deformity but without clinical comparison. In this study, we used 18 identical 3-dimensional (3D) prints of a patient with heel varus to compare the operative correction obtained with Dwyer, oblique, and Z osteotomies.

Methods: A computed tomography (CT) scan of a patient with heel varus was used to create 18 identical 3D prints of the talus, calcaneus, and cuboid. Coordinate frames were added to the talus and calcaneus to evaluate rotation. The prints were then divided into 3 groups of 6 models each. A custom jig precisely and accurately replicated each osteotomy. Following the simulated operations, cut models were CT scanned and compared with 6 uncut models. Measurements were calculated using multiplanar reconstruction image processing. An analysis of variance (ANOVA) was performed on the initial data to determine significant differences among the measured variables. A Tukey Studentized range test was run to compare variables that showed statistically significant differences using the ANOVA.

Results: The coronal angle of the Dwyer and oblique osteotomies was significantly less than that of the Z osteotomy ( P < .05). The axial angle, lateral displacement, and calcaneal shortening of the uncut model and Z osteotomy were significantly less than the Dwyer and oblique osteotomies.

Conclusions: Dwyer, oblique, and Z osteotomies did not create either lateral translation or coronal rotation without the addition of a lateralizing slide or rotation of the posterior tuberosity.

Clinical Relevance: Dwyer and oblique osteotomies would be best suited for mild deformity, yet the amount of calcaneal shortening must be acknowledged. A Z osteotomy is a complex procedure that has the capability of correcting moderate-severe coronal plane rotation but fails to provide lateralization of the pull of the Achilles insertion.

Download full-text PDF

Source
http://dx.doi.org/10.1177/1071100717753622DOI Listing

Publication Analysis

Top Keywords

dwyer oblique
20
heel varus
12
oblique osteotomies
12
patient heel
8
talus calcaneus
8
calcaneal shortening
8
osteotomies
5
dwyer
5
oblique
5
prints
4

Similar Publications

This report describes a case in which ankle-preserving surgery was performed for secondary ankle instability with good results in a patient with residual deformity after triple arthrodesis. A 42-year-old woman had undergone triple arthrodesis at the age of 16 years to correct a club foot deformity that had caused paralysis of the lower extremities. However, her left ankle instability worsened over time.

View Article and Find Full Text PDF

Background: There is limited consensus on the optimal operative technique for correcting heel varus in patients with Charcot-Marie-Tooth (CMT) disease. This comparative study evaluated the ability of 4 lateralizing calcaneal osteotomies, with and without Dwyer wedge resection and coronal rotation of the posterior tuberosity, to correct severe heel varus.

Methods: The computed tomography (CT) scan of a teenage CMT patient with severe hindfoot varus was used to create 3-dimensional (3D)-printed models of the talus, calcaneus, and cuboid.

View Article and Find Full Text PDF

Background: Few authors have directly compared multiple types of lateralizing calcaneal osteotomies (LCOs) in terms of their ability to achieve deformity correction. The aim of this research was to use a digital model of a varus hindfoot to compare 4 different LCOs in terms of deformity correction and amount of tuberosity lateralization required. The authors hypothesis was that osteotomies involving a wedge resection would achieve greater correction with less lateralization.

View Article and Find Full Text PDF

Background: Cavovarus deformity of the hindfoot is typically caused by neurologic disorders. Multiple osteotomies have been described for the correction of varus deformity but without clinical comparison. In this study, we used 18 identical 3-dimensional (3D) prints of a patient with heel varus to compare the operative correction obtained with Dwyer, oblique, and Z osteotomies.

View Article and Find Full Text PDF

Background: The traditional fixation for a calcaneocuboid (CC) arthrodesis in triple arthrodesis is with a 6.5-mm cancellous screw. This procedure can be technically challenging.

View Article and Find Full Text PDF