MRI-guided breast biopsy at 3T using a dedicated large core biopsy set: feasibility and initial results.

Objective: The increasing importance of breast MRI in the diagnostic processes concerning breast cancer yield often lesions that are visible on MRI only. To assess the nature of these lesions, pathologic analysis is necessary. Therefore, MR-guided biopsy should be available. Breast MRI at 3T has shown advantage over 1.5T. Unfortunately, current equipment for MR-guided biopsy is better suited for intervention at 1.5T due to the danger of heating titanium co-axial sleeves and large susceptibility artifacts. We evaluated a dedicated 3T breast biopsy set that uses plastic coaxial needles to overcome these problems.

Materials And Methods: We performed MRI-guided breast biopsy in 23 women with 24 MRI-only visible breast lesions at 3T. Biopsy procedures were performed with plastic coaxial needles in a closed bore 3T clinical MR system on a dedicated phased array breast coil with a commercially available add-on stereotactic biopsy device.

Results: Width of the needle artifact was 2mm in all 24 cases. Biopsy procedure was completed between 35 and 67 min. The procedure was judged moderately easy in 12 and normal in 10 cases. One procedure was judged difficult and there was one technical failure.

Conclusion: MRI-guided breast biopsy at 3T is a fast and accurate procedure. The plastic coaxial needles reduce the susceptibility artifact largely and do not increase the difficulty of the procedure. The diagnostic yield is at least equal to the diagnostic yield of the same procedure at 1.5T. Therefore, this technique can be safely used for lesions only visible at 3T MRI.