Diffusive diffraction measurements in porous media: effect of structural disorder and internal magnetic field gradients.

J Magn Reson

Commissariat à l'Energie Atomique, Le Ripault, BP 16 37260, Monts (Tours), France.

Published: October 2007


Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

Pulsed Field Gradient NMR (PFG-NMR) method used to measure the self-diffusion coefficient of liquids can also be exploited to probe the local geometry of porous media. In most practical cases, the measured diffusion attenuation is generally Gaussian and can be interpreted in terms of an apparent diffusion coefficient. Using well chosen experimental conditions, a so called "diffusive diffraction" phenomenon can be observed in the diffusion curve with a specific shape and maxima location characteristic of the system local dimensions. In this paper we investigate this phenomenon by presenting new experimental results obtained on several porous model systems of packed sphere particles. Using different experimental approaches, the diffusion pattern could be finely observed and interpreted in the context of the pore hopping model formalism. Different calibrated systems of polystyrene and glass spheres with known mean diameter and polydispersity were used to investigate specifically the influence of structural heterogeneity and local internal gradients. Structural data obtained in that way were found in close agreement with laser diffraction granulometry measurement and Scanning Emission Microscopy.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jmr.2007.08.009DOI Listing

Publication Analysis

Top Keywords

porous media
8
diffusive diffraction
4
diffraction measurements
4
measurements porous
4
media structural
4
structural disorder
4
disorder internal
4
internal magnetic
4
magnetic field
4
field gradients
4

Similar Publications

Proto-SLIPS: Slippery Liquid-Infused Surfaces that Release Highly Water-Soluble Agents.

ACS Appl Mater Interfaces

September 2025

Department of Chemistry, University of Wisconsin-Madison, 1101 University Ave., Madison, Wisconsin 53706, United States.

Slippery liquid-infused porous surfaces (or "SLIPS") can prevent bacterial surface fouling, but they do not inherently possess the means to kill bacteria or reduce cell loads in surrounding media. Past reports show that the infused liquids in these materials can be leveraged to load and release antimicrobial agents, but these approaches are generally limited to the use of hydrophobic agents that are soluble in the infused oily phases. Here, we report the design of so-called "proto-SLIPS" that address this limitation and permit the release of highly water-soluble (or oil-insoluble) agents.

View Article and Find Full Text PDF

The oxygen reduction reaction (ORR) is critical to energy conversion technologies and requires efficient catalysts for superior performance. Herein, nitrogen-doped carbide-derived carbon (N-CDC) catalysts are prepared using novel engineered molecular architectures based on polymer-derived ceramic technology. The obtained catalyst materials show a surface N concentration of >5 wt % and a hierarchically porous structure, resulting in a specific surface area of over 2000 m g.

View Article and Find Full Text PDF

SnS (tin disulfide) is a promising anode active material for lithium-ion batteries (LIBs) due to its high theoretical capacity and low material cost. Conventional synthesis methods, such as solvothermal, hydrothermal, and solid-state, require long synthesis times, the use of solvents and surfactants, and several separation steps. However, the preparation of coated SnS composites using liquid media is even more complex, requiring suitable precursors, compatible solvents, and potentially several steps.

View Article and Find Full Text PDF

Porous Environmental Polarity as a Critical Descriptor for Efficient Proton Conductivity in Metal-Organic Frameworks.

Langmuir

September 2025

Key Laboratory of Green Chemical Media and Reactions (Ministry of Education), Collaborative Innovation Center of Henan Province for Green Manufacturing of Fine Chemicals, School of Chemistry and Chemical Engineering, Henan Normal University, Xinxiang, Henan 453007, P. R. China.

Recent years have witnessed growing research interest in proton-conducting metal-organic frameworks (MOFs) owing to the characteristics of highly ordered pores, oriented packing of crystals, and particularly designable structures. However, how to construct a suitable microenvironment in MOF pores to form optimal proton transport pathways remains challenging. In this study, four MOFs with similar porous diameters but different microenvironments have been screened to study how porous environments influence proton conduction for the first time.

View Article and Find Full Text PDF

Vertical cutoff wall is widely used as one of the in-situ remediation technologies for contaminated sites. In this paper, considering the unsaturated characteristics of porous media, a three-dimensional pollutant transport model of inner aquifer-vertical cutoff wall-outer aquifer is established. The main conclusions are as follows.

View Article and Find Full Text PDF