Category Ranking

98%

Total Visits

921

Avg Visit Duration

2 minutes

Citations

20

Article Abstract

A new, analytically valid procedure is described to assess the exposure of human beings to the so-called microbial volatile organic compounds (MVOCs) in air. The method can be used routinely for large sample numbers and is especially valuable as a basis for further research on the correlation between single MVOCs and indoor mould growth. The procedure is based on the fact that fungi produce a variety of volatile organic compounds, such as 3-methylbutan-1-ol, 3-methylbutan-2-ol, fenchone, heptan-2-one, hexan-2-one, octan-3-one, octan-3-ol, pentan-2-ol, alpha-terpineol, and thujopsene, which they emit into the indoor environment. Using diffusive samplers, these MVOCs are adsorbed onto charcoal during a sampling interval of four weeks. The described method is thus superior to existing methods which use short-term active sampling. After desorption with carbon disulfide, the MVOCs were determined by dual-column gas chromatography with flame ionization detection using the large-volume injection technique for sample introduction. The detection limits ranged between 0.15 and 0.53 microgram m-3, within-series precision was found to range between 6.5 and 19.0%, and recovery was between 77 and 118%. The procedure has been successfully applied in the context of a large field study to measure the indoor MVOC exposure in children's rooms of 132 dwellings. The objective of the study was to examine the relation between indoor mould growth, the indoor MVOC exposure and the prevalence of adverse health effects. Information about mould formation has been obtained by a questionnaire and by the determination of colony forming units of mould fungi in mattress dust. With the exception of 3-methylbutan-2-ol, fenchone, nonan-2-one, octan-2-one, and thujopsene, indoor air concentrations of all MVOCs under investigation were significantly higher inside damp and mouldy dwellings. From the primary MVOCs under investigation, 3-methylbutan-1-ol, hexan-2-one, heptan-2-one, and octan-3-ol were found to be most reliable indicators for mould formation. A correlation was also found between selected MVOCs and the occurrence of mould species in mattress dust. Aspergillus sp. correlated with heptan-2-one, hexan-2-one, octan-3-ol, octan-3-one, and alpha-terpineol, while the occurrence of Eurotium sp. was correlated with higher indoor air concentrations of 3-methylbutan-1-ol, 3-methylbutan-2-ol, heptan-2-one, hexan-2-one, octan-3-ol, and thujopsene. Children living in dwellings with elevated MVOC levels had a higher prevalence of asthma, hay fever, wheezing, and irritations of the eyes. These positive associations persisted after controlling for confounding factors such as age, sex, body-mass index, number of siblings, social status, passive smoking, type of heating, and ventilation habits. However, they were not statistically significant. This lack of significance may be a result of the small number of investigated samples.

Download full-text PDF

Source
http://dx.doi.org/10.1039/a903034dDOI Listing

Publication Analysis

Top Keywords

volatile organic
12
organic compounds
12
indoor mould
12
heptan-2-one hexan-2-one
12
microbial volatile
8
indoor
8
mould growth
8
3-methylbutan-1-ol 3-methylbutan-2-ol
8
3-methylbutan-2-ol fenchone
8
indoor mvoc
8

Similar Publications

Direct Effects of Polyploidization on Floral Scent.

J Chem Ecol

September 2025

Department of Environment and Biodiversity, University of Salzburg, Hellbrunner Strasse 34, Salzburg, 5020, Austria.

Polyploidy is an important driver of the evolution and diversification of flowering plants. Several studies have shown that established polyploids differ from diploids in floral morphological traits and that polyploidization directly affects these traits. However, for floral scent, which is key to many plant-pollinator interactions, only a few studies have quantified differences between established cytotypes, and the direct effects of polyploidization on floral scent are not yet known.

View Article and Find Full Text PDF

NO reduction to HONO by small α-hydroxycarbonyls: a laboratory investigation relevant to nighttime production of atmospheric HONO.

Phys Chem Chem Phys

September 2025

School of Chemical Sciences, Indian Association for the Cultivation of Science, 2A Raja S C Mullick Road, Jadavpur, Kolkata 700032, India.

This work presents a gas-phase experimental study on the reduction of NO (nitrogen dioxide) to HONO (nitrous acid) by two atmospherically significant volatile organic compounds (VOCs), namely, glycolaldehyde (Gla) and hydroxyacetone (HAc), under a simulated tropospheric condition. FTIR spectroscopic probing reveals that HONO is the only gaseous reduced product of NO in each reaction. The measured data indicate that the reactions in both cases occur in a 2 : 1 stoichiometry with respect to NO and Gla/HAc.

View Article and Find Full Text PDF

Ionic liquids (ILs) are a class of organic salts with melting points below 100°C. Owing to their unique chemical and physical properties, they are used as solvents and catalysts in various chemical transformations, progressively replacing common volatile organic solvents (VOCs) in green synthetic applications. However, their intrinsic ionic nature can restrict the use of mass spectrometric techniques to monitor the time progress of a reaction occurring in an IL medium, thus preventing one from following the formation of the reaction products or intercepting the reaction intermediates.

View Article and Find Full Text PDF

The study of electrochemical oxidations has wide-ranging implications, from the development of new electrocatalysts for fuel cells for energy conversion, to the synthesis of fine chemicals. 2,2,6,6-Tetramethylpiperidine-1-oxyl (TEMPO) has been used for decades as a sustainable, metal-free mediator for chemical oxidations and is now being used for electrochemical oxidations. We describe here a novel approach to TEMPO-mediated electrooxidations, in which the chemical input and waste generated during electrooxidations of alcohols are minimized by using a multifunctional room temperature ionic liquid (RTIL) to facilitate flow electrosynthesis.

View Article and Find Full Text PDF

Naomaohu lignite (NL) from Hami, Xinjiang, was ultrasonically extracted with a mixed solvent of CS and acetone (in equal volumes) to obtain the extract residue (ER). The ER was then separated based on density differences with CCl to yield the corresponding light residue (NL-L). The composition and structural characteristics of the light residue were characterized by proximate, ultimate, infrared, and thermogravimetric analyses (TG-DTG).

View Article and Find Full Text PDF