Investigation of PZT Materials for Reliable Piezostack Deformable Mirror with Modular Design.

This article presents a study of the electrophysical properties of a piezoceramic material for use in adaptive optics. The key characteristics that may be important for the manufacturing of piezoelectric deformable mirrors are the following: piezoelectric constants (d, d, d), capacitance, elastic compliance values s for different crystal directions, and the dielectric loss tangent (tgδ). Based on PZT ceramics, the PKP-12 material was developed with high values of the dielectric constant, piezoelectric modulus, and electromechanical coupling coefficients.

Improving focusability of post-compressed PW laser pulses using a deformable mirror.

The use of the post-compression technique ensures gain in laser pulse peak power but at the same time degrades beam focusability due to the nonlinear wavefront distortions caused by a spatially nonuniform beam profile. In this paper a substantial focusability improvement of a post-compressed laser pulse by means of adaptive optics was demonstrated experimentally. The Strehl ratio increase from 0.

High-spatial resolution stacked-actuator deformable mirror for correction of atmospheric wavefront aberrations.

Deformable mirrors are vital components of any adaptive optical system. Considering such a crucial role in compensation of incident wavefront distortions, the main requirements are imposed on these elements that determine performance of the entire system. To correct for phase distortions in high-power laser complexes a stacked-actuator deformable mirror with water cooling was developed.

Laser beam focusing through a moderately scattering medium using a bimorph mirror.

The rarely considered case when the optical radiation passes through the weakly scattering medium, e.g. mid-density atmospheric fog with the number of scattering events up to 10 was investigated in this paper.

Bimorph deformable mirror with a high density of electrodes to correct for atmospheric distortions.

This paper presents a new development of small-diameter, high-spatial-resolution, semipassive bimorph deformable mirrors to be used in different imaging systems. To manufacture the small control elements, laser engraving technology is used. An ultrasonic welding technique to connect the wires to the electrodes (actuators) is applied for this kind of mirror.

Extremely high-power CO2 laser beam correction.

This paper presents the results of high-power CO2 laser-aberration correction and jitter stabilization. A bimorph deformable mirror and two tip-tilt piezo correctors were used as executive elements. Two types of wavefront sensors, one Hartmann to measure higher-order aberrations (defocus, astigmatism etc.